McCulloch 966564101, ZM4619 manual Adjusting the Mower Deck, Deck Leveling

Page 41

MAINTENANCE

Adjusting the Mower Deck

Deck Leveling

Adjust the deck while the mower is on a level surface. Make sure the tires are inflated to the correct pressure. See Transmission under Technical Data.

If tires are under or over inflated, the deck cannot be properly adjusted.

The deck should be adjusted slightly higher in the rear.

NOTE: To insure accuracy of leveling procedure, mower deck drive belt must be installed prior to leveling deck.

1.Wear heavy gloves. Turn each outer blade tip to align with the deck or in a side-to-side manner.

2.Measure from the floor surface up to the bottom of the blade tip on the discharge side of the mower deck. Retain this measurement.

3.Move to the opposite side, check that measurement is the same. If adjustment is required—with a ¾" or adjustable wrench, turn the lift link adjustment nuts on either side counter clockwise to lower or clockwise to raise. Adjust until both side-to-side measurements are equal.

4.Turn any blade to align with the deck in front- to-rear manner. If the rear blade tip does not measure 1/8" to ½" higher, follow the front adjustment instructions that follow.

5.With a 5/8 or adjustable wrench, turn the nuts on the front suspension linkage. Clockwise raises the front of the mower, counter clockwise will lower the front. Adjust nuts until rear of mower deck is positioned level to 1/8" higher in the rear than the side-to-side measurement.

NOTE: This will place the mower deck in a base measurement position. Additional adjustment may be required to achieve desired cut for the type of grass or conditions being mowed.

8058-030

Lift link adjustment nut

8058-031

Deck front adjustment nuts

41

Page 40 Page 42
Image 41
Page 40 Page 42
Contents Operator Manual Page Table of Contents Page Introduction Manufacturing Number Good ServiceSymbols and decals Manual Performing any General Operation SafetySafety Instructions Never take passengers Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline General Maintenance Risk of sparking Spark Arrestor TransportControl Locations ControlsMotion Control Levers Unlocking Transmission Seat Adjustment LeverBypass Linkage Fuel Tank Throttle Control Ignition SwitchChoke Control Cutting Height Adjuster Blade SwitchParking Brake Always use the high position to transportFuel Shut Off Valve FusesSteering TrainingStarting the Engine Before StartingPlace controls in neutral position USE Full Throttle When Mowing To remove cables, reverse order Weak BatteryRunning Mower deck’s anti-scalp rollers should be evenly adjustedOperating On Hills Mowing Tips Stopping the Engine Manual Transport Maintenance Schedule MaintenanceBefore After Year 100 Replacing battery BatteryTire Pressures Safety SystemDeck Belt Removal Faulty adjustment can cause an accidentDeck Belt EZT Belt Installation Deck Belt InstallationPump Belt Replacing EZT E-Series Zeroturn Transaxle beltAnti-scalp Rollers Blade replacementCutting Blades Deck Leveling Adjusting the Mower DeckUse protective glasses when cleaning and washing CleaningCaster Wheels HardwareGeneral LubricationLubrication Schedule Deck Spindles Wheel and Deck ZerksFront Wheel Mount Front Wheel BearingsMaintenance section Trouble ShootingProblem Cause Trouble Shooting Winter Storage ServiceStorage Schematic Torque Specifications Technical DataHex Head Cap Screws Standard HardwareTransmission ZM4619Engine Productivity Overall dimensionsZM4619 Equipment CE requirements Conformity CertificatesUSA requirements Delivery Service Service JournalAction Stamp, signAfter 10 hours Daily ServiceHour Service Service Journal At least once each year Action Date, mtr reading Stamp, sign Page 115 349428R1 03/08/10
Top Page Image Contents