McCulloch MC30 manual HOW to USE Your Riding Mower, To SET Parking Brake, Ground Drive, Stopping

RIDING MOWER	MODEL NUMBER MC30 (96022001300)
CHASSIS	PRODUCT NUMBER 960 22 00-13

The operation of any riding mower can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear

safety glasses or eye shields while operating your riding mower or performing any adjustments or repairs. We recommend a wide vision

00155 safety mask over spectacles or standard safety glasses.

100	35							18
101
						44
							105
10
		103		110
40		102
			45					26
39		11		45	16		110
		40
34							53	53
41		39					65
	45	34						97
42
		41
2		106					60	55
52							67	57
43	42							56
	52							59
								29
				63	67		53	54
71
				64			68	53
							67
84					66		45
		82	64	62	7			92
74				113

HOW TO USE YOUR RIDING MOWER

TO SET PARKING BRAKE

Your riding mower is equipped with an opera- tor presence sensing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.

1.Depress brake pedal all the way down and hold.

2.Pull parking brake lever up and hold, release pressure from brake pedal, then release parking brake lever. Pedal should remain in brake position. Ensure parking brake will hold mower secure.

GROUND DRIVE -

•To stop ground drive, depress brake pedal all the way down.

•Move motion control lever to neutral posi- tion.

Motion Control Lever

ENGINE -

•Move throttle control between half and full speed (fast) position.

NOTE: Failure to move throttle control be- tween half and full speed (fast) position, be- fore stopping, may cause engine to “backfire”.

83		85					96
69							45
13	86	70	33				112
							45
				32		113
							112
	109
					32
							111

Throttle

67
45						108		23
14						1	22
51
45
107						67
			45	19		45	88	67
			15
				45
						104
98	24	25		94
72	8	24		91		45		45
		87			95
		72	81	79
			82			77 76
			78
73		45		73
LRV-B_Chassis_8					80

STOPPING

MOWER BLADE -

•To stop mower blade, move deck clutch lever to disengaged position.

(	) Deck Clutch	(	) Deck Clutch
	Control		Control
	“Engaged”		“Disengaged”

•Turn ignition key to “STOP” position and remove key. Always remove key when leaving riding mower to prevent unauthor- ized use.

IMPORTANT: Leaving the ignition switch in any position other than "STOP" will cause the battery to discharge and go dead.

NOTE: Under certain conditions when riding mower is standing idle with the engine run- ning, hot engine exhaust gases may cause “browning” of grass. To eliminate this pos- sibility, always stop engine when stopping riding mower on grass areas.

CAUTION: Always stop riding mower completely, as described above, before leaving the operator's position.

32 13