McCulloch MC1538ST manual To Adjust Steering Wheel ALIGN- Ment, Front Wheel TOE-IN/CAMBER

Page 21

SERVICE AND ADJUSTMENTS

TO ADJUST STEERING WHEEL ALIGN- MENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 22)

Block up axle securely.

Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

Repair tire and reassemble.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

BLACK cable fi rst from chassis and then from the fully charged battery.

RED cable last from both batteries.

02614

WEAK OR DEAD

FULLY CHARGED

BATTERY

BATTERY

FIG. 23

INTERLOCKS AND RELAYS

On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

Replace washers and snap retaining ring securely in axle groove.

Replace axle cover.

NOTE: To seal tire punctures and prevent fl at tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 22

TO START ENGINE WITH A WEAK BATTERY (See Fig. 23)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 24)

Raise hood.

Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

01536

FIG. 24

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, see engine manual.

TO ADJUST CARBURETOR

The carburetor has been preset at the factory and adjustment should not be necessary. However, minor adjustment may be required to compensate for differences in fuel, temperature, altitude or load. If the carburetor does need adjustment,

21see engine manual.

Image 21
Contents Model NO. MC1538ST MC1538STA Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Steering Wheel Unassembled PartsTools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidConnect Battery See Figs Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine To Start Engine See Fig Mowing TipsMaintenance General RecommendationsBefore Each USE Brake Operation TractorTires Operator Presence SystemEngine Clean AIR INTAKE/COOLING Areas CleaningMuffler Spark PlugsService and Adjustments To Install Mower See FigTo Remove Mower See Fig To Level Mower Housing To Replace Mower Blade Drive Belt See FigBelt Removal Belt Installation To Check and Adjust Brake See FigTo Adjust Brake To Replace Motion Drive Belt See FigTo Adjust Throttle Control Cable To Adjust Steering Wheel ALIGN- MentTo Adjust Carburetor Front Wheel TOE-IN/CAMBEROther StorageFuel System Engine OILTroubleshooting Points With attachment clutch Tractor - Model Number MC1538ST MC1538STA, Product no 77 SchematicElectrical KEY Part NO. NO. Description Chassis Repair Parts Drive Repair Parts Steering Repair Parts Optional Equipment EngineKEY Part NO. no Description SeatWheels & Tires DecalsMower Lift Mower Deck KEY Part Description Service Notes Service Notes Policy Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation

MC1538ST specifications

The McCulloch MC1538ST is a versatile and robust lawn mower designed for homeowners who seek performance combined with user-friendly features. This compact yet powerful mower is engineered to handle various mowing tasks effectively, making it a popular choice among gardening enthusiasts.

One of the standout features of the MC1538ST is its powerful 38cc engine. This engine provides ample power for cutting through thick grass and ensures reliable performance on different terrains. The durable steel cutting deck allows for a precise and clean cut, promoting a well-groomed lawn. The deck size of 38 cm makes it suitable for both small and medium-sized gardens, where maneuverability is crucial.

Another significant aspect of the MC1538ST is its unique cutting system. The mower comes with a three-in-one functionality; it can mulch, rear discharge, or collect grass clippings in a detachable bag. This versatility allows users to choose how they want to manage their grass clippings, enhancing the mowing experience while keeping the garden tidy.

The ergonomic design of the MC1538ST contributes to its ease of use. With a lightweight construction and comfortable handles, it is designed for effortless maneuverability. The mower features a foldable handle, making it easy to store in compact spaces. Moreover, the adjustable cutting height is another user-friendly feature, allowing for customization based on the grass type and desired length.

The MC1538ST adopts modern technology with its integrated safety features, including a safety switch that prevents unintended operation, enhancing user safety during mowing. The mower is also designed to minimize noise levels, providing a more pleasant mowing experience for both the user and any nearby neighbors.

In summary, the McCulloch MC1538ST is an excellent choice for those seeking a reliable and efficient lawn mower. With its powerful engine, versatile cutting options, and user-centric design, it streamlines the mowing process while ensuring an aesthetically pleasing lawn. Whether you’re a seasoned gardener or a novice, the MC1538ST will meet your lawn care needs with ease and efficiency.