McCulloch 96041011600 manual Install belt on engine pulley M

Page 20

SERVICE AND ADJUSTMENTS

•ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with retainer spring.

•Repeat on opposite side of tractor.

A

B

FIG. 17

•ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin (D) on rear mower bracket and secure with washer and retainer spring.

•Repeat on opposite side of tractor.

C

D

FIG. 18

•Insert end of link (E) into hole in front mower bracket and secure with washer and retainer spring (J).

E

FJ

H

FIG. 19

•Hook end of clutch cable spring (Q) into hole in idler arm (R).

•Push clutch cable housing guide (P) into bracket, slide collar (L) onto guide and secure with retainer spring (K).

•Install belt on engine pulley (M).

M

FIG. 20

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

•Raise attachment lift lever to highest position.

•If necessary, adjust gauge wheels before operating mower as shown in the Operation section of this manual.

•ATTACH FRONT LINK (E) - Work from left side of trac- tor. Insert rod end of link assembly through front hole in tractor front suspension bracket (F).

B

MF

Q R

P

K

A E

C

D

L	FIG. 21

20

Image 20

Contents M13538 Always Wear EYE Protection During OperationSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Contents of Hardware Pack Assembly Tools Required for AssemblyToremovetractorfromcarton Before Removing Tractor from SkidInstall Seat See Fig Check Battery See FigCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Attachment Clutch Lever Used to engageHOW to USE Your Tractor To SET Parking Brake See FigStopping See Fig To USE Throttle Control D See FigTo Adjust Mower Cutting Height See Fig To Move Forward and Backward See FigTo Operate Mower To Stop Mower BladesBefore Starting the Engine Mowing Tips To Start Engine See FigMaintenance Lubrication ChartBlade Removal See Fig BatteryTractor Engine Cleaning IN-LINE Fuel Filter See FigTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Figs Install belt on engine pulley M Visual SIDE-TO-SIDE Adjustment See Fig To Level MowerTransaxle Gear Shift Lever Neutral Adjustment See Fig To Adjust Steering Wheel AlignmentTo Replace Mower Blade Drive Belt See Fig To Check BrakeTo Start Engine with a Weak Battery See Fig Replacing Battery See FigTo Remove Wheel for Repairs See Fig To Attach Jumper CablesTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Service Notes Service Notes Service Notes Suggested Guide for Sighting Slopes for Safe Operation