McCulloch 96041011501, 532 42 27-27 Rev. 2 Storage, Other, Fuel System, Engine OIL, Cylinders

Page 24

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (See “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents M11577 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Unassembled Parts Steering WheelAssembly Tools Required for AssemblyToremovetractorfromcarton Before Removing Tractor from SkidInstall Seat See Fig Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Attachment Clutch Switch Disengaged EngagedTo SET Parking Brake See Fig Stopping See FigTo Adjust Mower Cutting Height See Fig To Move Forward and Backward See FigTo Operate Mower To Stop Mower BladesBefore Starting the Engine Mowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigTransaxle Maintenance EngineBelts LubricationCleaning Clean AIR ScreenAIR Filter MufflerService and Adjustments To Install Mower See FigTo Remove Mower See Fig Raise attachment lift lever to highest position Visual SIDE-TO-SIDE Adjustment See Fig To Level MowerBelt Installation To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig To Check BrakeTransaxle Gear Shift Lever Neutral Adjustment See Fig To Adjust Steering Wheel AlignmentTo Start Engine with a Weak Battery See Fig To Remove Wheel for Repairs See FigTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionExcessive Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX10.29.09 BM

532 42 27-27 Rev. 2, 96041011501 specifications

The McCulloch 96041011501,532 42 27-27 Rev. 2 is a standout model within the McCulloch line of outdoor power equipment, known for its robust design and high-performance features. As a chain saw primarily aimed at professionals and dedicated homeowners, this model delivers an exceptional balance of power, precision, and user convenience.

One of the key features of the McCulloch 96041011501 is its powerful engine, which boasts a striking performance capability. With a robust engine displacement, this chainsaw is equipped to handle a variety of cutting tasks, from felling large trees to trimming branches with ease. The engine's design emphasizes fuel efficiency, helping users maximize their productivity while minimizing fuel consumption.

The 42 cm (16.5 inches) guide bar provides a perfect balance between maneuverability and cutting capacity. It allows for precise cuts in tight spaces while maintaining efficiency during larger cuts. The chain used in this model has been engineered for rapid cutting, ensuring that users can tackle tough jobs without excessive effort. Additionally, the low kickback chain enhances safety for the operator, making it a reliable choice for both experienced users and novices.

Innovative technologies incorporated into the McCulloch 96041011501 further enhance its performance and usability. The Easy Start system simplifies the starting process, reducing the physical strain on the user. This feature is particularly advantageous for those who may need to start the saw multiple times during a job. The anti-vibration system significantly reduces user fatigue, allowing for longer operating periods without discomfort.

Safety remains a top priority in the design of this chainsaw. Equipped with a chain brake, the McCulloch 96041011501 ensures that users have an additional layer of protection against accidental chain movement. The ergonomic handle design not only promotes comfort but also provides a secure grip, further increasing user safety.

In summary, the McCulloch 96041011501,532 42 27-27 Rev. 2 is a formidable tool in the realm of chainsaws. With its combination of powerful performance, innovative features, and user-centric design, this model stands out as an excellent choice for anyone in need of a reliable, efficient, and safe chainsaw for their outdoor cutting tasks. Whether for professional use or home maintenance, the McCulloch 96041011501 is a testament to quality engineering and practical functionality.
Top Page Image Contents