Sears 917.28861 Operación, Cleaning, Deck Washout Port, On the tractor, re-start the engine

OPERACIÓN

Estos símbolos pueden aparecer sobre su tractor o en la literatura proporcionada con el producto. Aprenda y comprenda sus significados.

MARCHA ATRÁS	NEUTRO	ALTO		BAJO	ESTRANGU-	RÁPIDO		LENTO
					LACIÓN
MOTOR		MOTOR		MOTOR	FRENO DE		ALTURA DE LA		LEVANTAMIENTO
APAGADO	SISTEMA ENCENDIDO			EN MARCHA	ESTACIONAMIENTO		SEGADORA		DE LA SEGADORA
FUNCIONAMIENTO
ATRÁS (ROS)
LUCES		BATERÍA		MARCHA	MARCHA	PALANCA DE MANDO
ENSENDIDAS COMBUSTIBLE									PEDAL DE FRENO /
				ATRÁS HACIA ADELANTE			CRUCERO		DE EMBRAGUE
								15	15
ACCESORIO DEL	ACCESORIO DEL		PELIGRO, GUARDE LAS			MANTENGA EL			PELIGROS DE
EMBRAGUE	EMBRAGUE		MANOS Y LOS PIES LEJOS
ENGANCHADO	DESENGANCHADO				AREA DESPEJADA				PENDIENTES

CLEANING

•Clean engine, battery, seat, finish, etc. of all foreign matter.

•Clean debris from steering plate. Debris can restrict clutch/brake pedal shaft movement, causing belt slip and loss of drive.

CAUTION: Avoid all pinch points and movable parts

Clutch/brake pedal
Clean
top side
Steering
Plate
	CAUTION:
Steering System, Dash,	Pinch

Nozzle	Hose
Adapter	Washout Port

4.Pull back the lock collar of the nozzle adapter and push the adapter onto the deck washout port at the left end of the mower deck. Release the lock collar to lock the adapter on the nozzle.

IMPORTANT: Tug hose ensuring connec- tion is secure.

5.	Turn the water on.
6.	While sitting in the operator’s position

RUEDA LIBRE

(Solamente para los modelos automatico)

No seguir las siguientes instrucciones puede provocar heridas o muerte. Los símbolos de aviso de seguridadse utilizan para identificar informaciones de seguridad relativas a peligros que puedenprovocar la muerte, heridas graves y/o daños a la máquina.

(Vea la sección de las reglas de seguridad)

PELIGRO indica un peligro que, si no se evita, provoca muerte o lesiones graves.

ADVERTENCIA indica un peligro que, si no se evita, puede provocar muerte o lesiones graves.

PRECAUCIÓN indica un peligro que, si no se evita, puede provocar lesiones ligeras o moderadas.

PRECAUCIÓN cuando se utiliza sin el símbolo de aviso, indica una situación que puede provocar daños al tractor y/o al motor.

SUPERFICIES CALIENTES indica un peligro que, si no se evita, puede provocar la muerte, lesiones graves y/o danos a la máquina.

FUEGO indica un peligro que, si no se evita, puede provocar la muerte, lesiones graves y/o danos a la máquina.

Fender and Mower Not Shown Points

•Keep finished surfaces and wheels free of all gasoline, oil, etc.

•Protect painted surfaces with automo- tive type wax.

We do not recommend using a garden hose or pressure washer to clean your tractor unless the engine and transmission are covered to keep water out. Water in engine or transmission will shorten the useful life of your tractor. Use compressed air or a leaf blower to remove grass, leaves and trash from tractor and mower.

DECK WASHOUT PORT

Your tractor’s deck is equipped with a washout port on its surface as part of its deck wash system. It should be utilized af- ter each use.

1.Drive the tractor to a level, clear spot on your lawn, near enough to a water spigot for your garden hose to reach.

IMPORTANT: Make certain the tractor’s discharge chute is directed AWAY from your house, garage, parked cars, etc. Remove bagger chute or mulch cover if attached.

2.Make sure the attachment clutch control is in the “DISENGAGED” position, set the parking brake, and stop the engine.

3.Thread the nozzle adapter (packaged with your tractor’s Operator’s Manual) onto the end of your garden hose.

on the tractor, re-start the engine and

place the throttle lever in the Fast " "

position.

IMPORTANT: Recheck the area making certain the area is clear.

7.Move the tractor’s attachment clutch control to the “ENGAGED” position.

Remain in the operator’s position with the cutting deck engaged until the deck is cleaned.

8.Move the tractor’s attachment clutch control to the “DISENGAGED” posi- tion. Turn the ignition key to the STOP position to turn the tractor’s engine off. Turn the water off.

9.Pull back the lock collar of the nozzle adapter to disconnect the adapter from the nozzle washout port.

10.Move the tractor to a dry area, prefer- ably a concrete or paved area. Place the attachment clutch control in the “ENGAGED” position to remove excess water and to help dry before putting the tractor away.

WARNING: A broken or missing washout fitting could expose you or others to thrown objects from contact with the blade.

•Replace broken or missing washout fitting immediately, prior to using mower again.

•Plug any holes in mower with bolts and locknuts.

48 25