,,,ui
ASSEMBLY
HOW TO ASSEMBLE
THE STEERING WHEEL
Use the fasteners shown below to install the steering wheel The fasteners are shown at full slze
A |
| © | A | |
|
|
|
| Steeling Wheel |
1x102 | Bottom | B | Top | B |
| View | 15x88 | View | Beaows |
|
| |||
1Make sure the front wheels point forward Slide the bellows over the steering post Make sure the collar of the bellows is
D 5699
on top Push on the top of the bellows
2Attach the steering wheel to the steering post with the fas- teners as shown Tighten the fasteners
HOW TO ATTACH THE HUB CAPS
Push each hub cap onto the center hub of each wheel Make sure the washer holds the hub cap in place
CHECK THE BELTS
Check the routing of the belts Make sure the belts are not twisted Make sure the belts are inside all the belt guides
| i r,i | ,,111 |
|
| Motion | Drive |
|
Belt Guide | Belt |
|
|
|
| Guide |
|
|
| Mower Drive |
|
|
| Belt | Belt Guide |
|
|
| |
Transaxle Pul{ey |
|
|
|
|
|
| Pulley |
Belt Guide" /
CHECK THE TIRES
Check the alr pressure in the tires Tires with too much air pressure will cause the unit to ride rough Also, the wrong air pressure will keep the mower houslng from cutting level The correct air pressure (PSI) for each Rear Wheel is 14 PSI (10 kg/cm2) and for
each Front Wheel the air pressure is 24 PSI (16 kg/cm2) Models
that have
F_92533 | 9 |
CHECK THE DRIVE BRAKE
The drive brake can be easily checked as follows Set the parking brake Move the shift lever to the neutral (N) posltlon_ Push the unit If the rear wheels rotate, adjust the drive brake See "How To Check And Adjust The Ddve Brake"