Sears 917.256543 Operation, Before Starting the Engine, To Operate Mower See Fig, To Transport

Page 13

,

,i ii. ,i,,,,11,,,,,,,,11-,111,1

....

i.-m

OPERATION

TO OPERATE MOWER (See Fig. 10)

Your tractor is equipped with an operator presence sens- ing switch, Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.

oSelect desired height of cut

oLower mower with attachment lift control,

°Start mower blades by engaging attachment clutch control°

°TO STOP MOWER BLADES - disengage attachment clutch control.

i,, ii ,,i,,

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the dis- charge guard in place.

oTo restart movement, slowly release parking brake and clutch/brake pedal°

o Make all turns slowly.

TO TRANSPORT

=Raise attachment lift to highest position with attach- ment lift control.

°When pushing or towing yourtractor, be sure gearshift lever is in neutral (N) position

. Do not push or tow tractor at more than five (5) MPH.

NOTE: To protect hood from damage when transporting your tractor on a truck or atrailer, be su re hood is closed and secured to tractor, Use an appropriate means of tying hood to tractor (rope, cord, etc.)o

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL (See Fig. 17)

The engine inyour tractor has been shipped, from the factory, already filled with summer weight oil,

Check engine oil with tractor on level ground.

Unthread and remove oil fill cap/dipstick; wipe oil off. Reinsert the dipstick intothe tube and rest oil fill cap on the tube. Do not thread the cap onto the tube. Remove and read oil level,, If necessary, add oil until "FULL" mark on dipstick is reached, Do not overfill,

. For cold weather operation you should change oil for easier starting (See "OIL VISCOSITY CHART" in the Customer Responsibilities section of this manual).

oTo change engine oil, see the Customer Responsibili- ties section in this manual

FIG. 10

TO OPERATE ON HILLS

ii ii ,,,,,,,ll ,,i,,i,ii ,i

hills with slopes greater than 15 ° and I

ICAUTION: Do not drive up or down i

do not drive across any slope.I

L

. Choose the slowest speed before starting up or down hills.

. Avoid stopping or changing speed on hills

. If slowing is necessary, move throttle control lever to slower position.

If stopping is absolutely necessary, push clutch/brake

_edal quickly to brake position and engage parking rake.

-Move gearshift lever to 1st gear. Be sure you have allowed room for tractor to roll slightly as you restart movement

ADD GASOLINE

oFill fuel tank,. Use fresh: clean, regular unleaded gasoline with a minimum of 87 octane° (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness

IMPORTANT: WHEN OPERATING IN TEMPERATURES

BELOW 32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER

STARTINGo

WARNING: Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage Acidic gas can damage the fuel system of an engine while in storage To avoid engine problems, the fuel system should be emptied before stor- age of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instruc- tions for additional information Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

CAUTION: Fill to bottom of gas tank filter neck. Do not overfill. Wipeoffany spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

13

Image 13
Contents Model Number 917.256543 Ownersmanual Lb Safe Operation Practices for Ride-On Mowers Safety RulesModel Maintenance AgreementSerial Number Date of Purchase Undex Performance AOOE$$OR! and Attach EntsContents of Hardware Pack To Remove Tractor from Carton Connect Battery See FigsBefore Rolling Tractor OFF Skid Unpack CartonCheck TiRE Pressure Install Seat See FigCheck Deck Levelness Check Brake SystemInstall IVlULCHER Plate See Figs ChecklistTo Convert to Bagging or Discharging WeldnutfromthoOperation Know Your Tractor Ignition Light Switch Ammeter PositionTo SET Parking Brake See Fig Howto USE Your TractorTo USE Throttle Control See Fig Stopping See FigBefore Starting the Engine OperationTo Operate Mower See Fig To TransportTo Start Engin = See Fig Mowing TupsIviulchjng iVtOWING TiPS General Recommendations Lubrication ChartBefore Each USE AS YOU CompleteTractor Custom Responsibil ESTires Transaxle Cooling EngineLubrication Customer CleanAIR INTAKF.JCOOLiNG AreasEngine OIL Filter See Fig CleaningTo Remove Mower See Fig To iNSTALL iVIOWER See FigTo Level Mower Housing Service AN AdjustmentsBelt Installation To Adjust Brake See FigTo Replace Mower Blade Drive Belt To Replace Motion Drive BeltTo Start Engine WEH a Weak Battery See Fig To Adjust Steering Wheel AlignmentTransaxle Shifter Linkage and AD- Justment See Figs Front Wheel TOE-IN/CAMBERTo Remove Hood and Grill Assembly AdjustmentsTo Replace Headlight Bulb To Replace FuseTo Adjust Carburetor See Fig To Adjust Throttle Control CableTurned in TOO Tight Engine OIL Fuel SystemCylinders Correction Troubleshootbng PointsTroubleshootsng Points