Checklist, Install IVlULCHER Plate See Figs

.......... i	,,,	,
...............	i

LOCKNUT

3/8" WASHER

GAUGE WHEEL

_/SHOULDERBOLT

FIG. 5

INSTALL IVlULCHER PLATE

(See Figs. 6 & 7)

oInstall two latch hooks to mulcher plate using screw, washer, lock washer, and weld nut as shown.

NOTE: Pre-assemble weld nut to latch hook by inserting weld nut from the top with hook pointing down.

-Tighten hardware securely.

o Raise and hold deflector shield in upright position.

=Place front of mulcher plate over front of mower deck opening and slide into place, as shown,

oHook front latch into hole on front of mower deck° ° Hook rear latch into hole on back of mower deck..

CAUTION: Do not remove discharge guard from mower, Raise and hold guard when attaching mulcher plate and allow it to rest on plate while in operation.

HOOK POINTS DOWN

WELDNUTFROMTH_O_---_

	LOCK	___
WELD	WASHER	\	-	_J/_
NUT _	SCREW	_
LATCH

_,,,_ ....

illl,

i, ,,ll,,

TO CONVERT TO BAGGING OR

DISCHARGING

Simply remove mulcher plate and store in a safe place. Your mower is now ready for discharging or installation of optional grass catcher accessory°

NOTE: It is not necessary to change blades.. The mulcher blades are designed for discharging and bagging also.

DEFLECTOR

LATCH

HOOKS

FIG. 7

,/CHECKLIST

BEFORE YOU OPERATE AND ENJOY YOUR NEW TRACTOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BESTPERFORMANCE AND SATISFACTION FROM THIS QUALITY PRODUCT.

PLEASE REVIEW THE FOLLOWING CHECKLIST:

,/ All assembly instructions have been completed°

_" No remaining loose parts in carton.

,/ Battery is properly prepared and charged.. (Minimum 1 hour at 6 amps).

,./ Seat is adjusted comfortably and tightened securelyo

Z" All tires are properly inflated. (For shipping purposes, the tires were overinflated at the factory).

JBe sure mower deck is properly leveled side-to-side/ front-to-rear for best cutting results° (Tires must be properly inflated for leveling).

,/ Check mower and drive betts. Be sure they are routed properly around pulleys and inside all belt keepers.

v" Check wiring_ See that all connections are still secure and wires are properly clamped_

LOCK

LATCH HOOK

WELD

NUT

WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY EXTRA ATTENTION TO THE FOLLOWING IMPORTANT ITEMS:

,/ Engine oil is at proper level..

,z Fuel tank is filled with fresh, clean, regular unleaded

WASHERWASHER

WASHER

MULCHER

PLATE

gasoline.

v" Become familiar with all controls - their location and function° Operate them before you start the engine.

v" Be sure brake system is in safe operating condition.

FIGo6