Sears 917.256543 manual Adjustments, To Replace Headlight Bulb, To Replace Fuse, See Fig

Page 24

AND ADJUSTMENTS

POSITIVE TERMINAL

NEGATIVE TERMINAL

	CABLES
	CHARGED
	BATTERY
POSITIVE	NEGATIVE
TERMINAL	TERMINAL

FIG. 30

TO REPLACE HEADLIGHT BULB

o Raise hood..

oPull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

o Close hood..

mNTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, o_ prevent it from starting.

°Check wiring.. See electrical wiring diagram in the Repair Parts section of this manual

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in fuse The fuse holder is located behind the dash..

TO REMOVE HOOD AND GRILL ASSEMBLY

(See Fig. 31)

•Raise hood.

•Unsnap headlight wire connector.

oStand infront of tractoro Grasp hood at sides, tilt toward engine and lift off of tractor.

o To replace, reverse above procedures..

HOOD

HEADLIGHT

_IRE

CONNECTOR

FIG. 31

Image 24

Contents Model Number 917.256543 Ownersmanual Safety Rules Lb Safe Operation Practices for Ride-On MowersMaintenance Agreement ModelSerial Number Date of Purchase Undex AOOE$$OR! and Attach Ents PerformanceContents of Hardware Pack Connect Battery See Figs To Remove Tractor from CartonBefore Rolling Tractor OFF Skid Unpack CartonInstall Seat See Fig Check TiRE PressureCheck Deck Levelness Check Brake SystemChecklist Install IVlULCHER Plate See FigsTo Convert to Bagging or Discharging WeldnutfromthoOperation Ignition Light Switch Ammeter Position Know Your TractorHowto USE Your Tractor To SET Parking Brake See FigTo USE Throttle Control See Fig Stopping See FigOperation Before Starting the EngineTo Operate Mower See Fig To TransportMowing Tups To Start Engin = See FigIviulchjng iVtOWING TiPS Lubrication Chart General RecommendationsBefore Each USE AS YOU CompleteCustom Responsibil ES TractorTires Engine Transaxle CoolingLubrication Clean CustomerAIR INTAKF.JCOOLiNG AreasCleaning Engine OIL Filter See FigTo iNSTALL iVIOWER See Fig To Remove Mower See FigService AN Adjustments To Level Mower HousingTo Adjust Brake See Fig Belt InstallationTo Replace Mower Blade Drive Belt To Replace Motion Drive BeltTo Adjust Steering Wheel Alignment To Start Engine WEH a Weak Battery See FigTransaxle Shifter Linkage and AD- Justment See Figs Front Wheel TOE-IN/CAMBERAdjustments To Remove Hood and Grill AssemblyTo Replace Headlight Bulb To Replace FuseTo Adjust Throttle Control Cable To Adjust Carburetor See FigTurned in TOO Tight Fuel System Engine OILCylinders Troubleshootbng Points CorrectionTroubleshootsng Points