Preparing Your SAW for USE

A. GEEING READY

1. READ YOUR 0PERATOWS MANUAL

CAREFULLY'" .....

.......Your Operators; Manual has been developed to

i_ help you,prepare your saw for use and to under-

•Stand its safe operation. It is;important that you read your manual completely to become familiar with the unitbeforeyou begin assembly.

•, ,, H,,

2. HAVE THE FOLLOWING AVAILABLE:

a. Protective	gloves	_-..... '
b; Approved,	marked fuel	container

c. One gallon	leaded or	unleaded,		regular
gasoline	•	•	:	_ :_'
d. Bar and Chain Lubricant		(see page 9).

e. Scrench--provided with your unit. No other

. tool is necessary for assembly. The long end of the too! can be used as a slotted

screwdriver. The small PiPe end canbe us-

B. ATTACHINGTHE HANDGUARD

The Handguard is a protective device designed

to hetp prevent your hand from coming in con- tact with the cutting chain should your hand slip

off the handlebar, tt will not:eliminate the

possibility of injury from kickback or toss of con- _trol of.the saw. .........

CAP HANDGUARD HANDLE

.... : :i:" ::-iFigure 1 :_

?_ _

WARNING! .......

Do not use the saw without the handguard in

place.,

•Lift and carry the chain saw by the handlebar or rear handle, not by the handguard.

•Keep the handguard securely fastened at all times. Check the handguard screws each time the saw is used. ....

To install:

1. Alignthe Handguard and Handguard Cap around the handlebar as shownin Figure 1.

2.Fit the imounting pin on the Handguard into the hole in the handlebar. Figure 1.

3.Insert the 3 mounting screws into the 3 holes on the Handguard Cap.

4.Turn .each screw a little at a time clockwise, until the Handguard Cap and Handguard meet and there is no gap between the two parts.

C. ATTACHING		THE	SPUR
The spur is a special piece,of equipment de-
signed to	assist	the	cutting operation.	When
assembled	to the	saw,	the spur. will dig	into the
tree or log	and:		_i ....

--relieve contact pressure adding"ease to the sawing operation.

--allow the saw to be more easily rotated or pivoted into the cut.

To Install:

1.Remove Bar Clamp Nuts, Bar Clamp and Guide Bar Plates.

2.Align the spur over the two holes on the bar clamp side of the saw. Figure 2.

3.Insert the two screws and tighten evenly and securely.

i,,i

BAR

CLAMP. (

GUIDE BAR PLATES

BAR NUTS

Figure 2