Troy-Bilt 604 manual Lubrication

Page 24

TIRES

The recommended operating tire pressure is approximately 10 psi for the rear tires and 14 psi for the front tires. Refer to the tire sidewall for exact tire

manufacturer’s recommended psi. Do not overinflate. Uneven tire pressure could cause the cutting deck to mow unevenly.

SECTION 11: LUBRICATION

WARNING: Always stop the engine and disconnect the spark plug wire(s) and ground against the engine before performing any maintenance.

ENGINE

Lubricate the engine with motor oil as instructed in the separate engine manual packed with your unit.

PIVOT POINTS

Lubricate all pivot points (AutoDrivepedal, brake pedal, etc.) at least once a season with light oil.

LINKAGE

Lubricate all the pivot points on the drive, brake and lift linkage at least once a season with SAE 30 engine oil.

STEERING GEAR

Lubricate the teeth of the steering gear with an all-purpose automotive grease every 25 hours of operation or once a season.

WHEELS

Both the front wheels and the rear wheels should be removed from the axles once a season. Lubricate the axles and the rims well with an all-purpose automotive grease before re-installing them.

FRONT AXLES

Your tractor may be equipped with zerk fittings on the ends of the front pivot bar. See Figure 9. Lubricate both the left and the right front axles with a grease gun at least once a season.

24

Image 24
Contents OPERATOR’S Manual Table of Contents Finding Your Model NumberCalling Customer Support Important Safe Operation Practices General OperationService Slope OperationDo not ChildrenSafety Labels found on your unit Slope Gauge Or a Fence PostAttachments & Accessories Attaching the Battery CablesInstalling the Mulch KIT Tractor SET-UPControls Ignition Switch Indicator Monitor / Hour MeterThrottle Control Lever Choke ControlPTO Power TAKE-OFF Lever Lift LeverAutodrive Pedal Parking Brake ButtonSeat Adjustment Lever Safety Interlock SwitchesOperation Cruise Control ButtonSetting the Cutting Height Setting the Cruise ControlStarting the Engine Stopping the EngineUsing the Lift Lever Engaging the PTO Power TAKE-OFF LeverDriving on Slopes Operating the HeadlightsAdjustments MowingLeveling the Deck Seat Adjustment Steering AdjustmentFront to Rear Brake Adjustment Carburetor AdjustmentPTO Power TAKE-OFF Adjustment Maintenance EngineChanging Engine Oil Cleaning the Engine and Deck To Lift AssemblyCutting Deck Removal Front of TractorChanging the Deck Belts Inch decksChanging the Transmission Drive Belts Upper Drive BeltLower Drive Belt Transmission Cutting Blades HoleBattery FuseCharging Lubrication Troubleshooting Guide Trouble Possible Corrective Action CausesModel Part DescriptionElectrical System/Tractor Body Model Lift Assembly Model Steering Assembly Model Drive System 447 Power Take-off System Inch Deck Cutting Decks Briggs & Stratton Intek Twin Engine Accessories Briggs & Stratton Intek SingleMANUFACTURER’S Limited Warranty for