White Outdoor 500 Stopping Snow Thrower, Before Starting Gas & Oil Fill-Up, Starting The Engine

IMPORTANT: Always release the drive control before changing speeds.

Auger Control

The auger control is located on the left handle. Squeeze the auger control to engage the augers. Release to stop the snow throwing action. The drive control must also be released in order to stop the auger.

IMPORTANT: Refer to Auger Control Test on page 7 to adjust the auger control. Read and follow all instructions carefully and perform all adjustments to verify your snow thrower is operating safely and properly.

Ignition Key

The ignition key must be fully inserted in the switch before the unit will start. Remove key when snow thrower is not in use. Do not attempt to turn the key.

Discharge Chute

The angle of the discharge chute controls the distance that the snow is thrown. Tilt the discharge chute up for greater distance; tilt down for less distance.

Four Way Chute Control

This four-way control lever is meant to	6
control the direction and distance of	5
snow discharge from the chute. Press	4
the button on the knob and pivot it left	3
or right to rotate the chute to the
	2
direction that snow will be thrown. Tilt
	F 1
the lever forward or rearward to adjust
the distance snow will be thrown.

Shift Lever	R R1
The shift lever is located in the center	R2
of the handle panel and is used to
determine ground speed and direction
of travel. It can be moved into any of
eight positions.

IMPORTANT: Always release traction control before changing speeds.

Forward: The snow thrower has six forward (F) speeds. Position one (1) is the slowest and position six

(6) is the fastest.

Reverse: The snow thrower has two reverse (R) speeds—R1 is the slower of the two.

Headlight

The headlight is on whenever the engine is running.

Chute Clean-Out Tool

The chute clean-out tool is designed to clear a clogged discharge chute. Refer to page 12 for instructions on how to properly use it.

WARNING: Never use your hand to clear a clogged discharge chute. Shut off engine and remain behind handles until all moving parts have stopped before unclogging.

Wheel Steering Controls

The left and right wheel steering controls are located on the underside

of the handles. Squeeze the right

control to turn right; squeeze the left control to turn left.

NOTE: Operate the snow thrower in open areas until you are familiar with these controls.

Skid Shoe

The skid shoe position is determined by the condition of the ground from where snow has to be removed. Higher the snow level, lower will be the skid shoe level. Adjust it accordingly.

Stopping Snow Thrower

1.To stop the wheels, release the traction drive lever of the snow thrower.

2.To stop throwing snow, release the auger drive lever.

3.To stop the engine, push throttle control lever to OFF and pull out the ignition key. Do not turn key.

Before Starting

WARNING: Read, understand, and follow all instructions and warnings on the machine and in this manual before operating.

Gas & Oil Fill-Up

Service the engine with gasoline and oil as instructed in the separate engine manual packed with your snow thrower. Read instructions carefully.

WARNING: Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel the machine indoors or while the engine is hot or running. Extinguish cigarettes, cigars, pipes and other sources of ignition.

Starting The Engine

WARNING: Be sure no one other than the operator is standing near the snow thrower while starting or operating. Do not operate this snow thrower unless the discharge chute assembly has been properly installed and is secured.

•Attach spark plug wire to spark plug. Make certain the metal loop on the end of the spark plug wire

9