White Outdoor 933R, 933E manual Safety Decals, On top, rear of engine platform

Page 5

Section 1: Safety

10.Mower blades are sharp and can cut. Wrap the blade or wear gloves, and use extra caution when servicing them.

11.Do not change the engine governor setting or overspeed the engine.

12.Do not touch engine parts which may be hot from operation. Allow parts to cool completely before in- specting, cleaning or repairing the mower.

13.To access the underside of the mower, tip the mower rearward. Do not tip the mower forward or on ei- ther of its sides, unless specifically advised to do so in this manual.

14.Maintain or replace safety and in- structional decals. Refer to the sep- arate Parts Book for replacement decal information.

15.For units equipped with electric start:

a)Batteries produce explosive gases. Keep sparks, flame, cigarettes, etc., away. Ventilate the area when charging the bat- tery. Do not charge the battery in an airtight space.

b)Do not use a battery charger other than the one provided with the mower.

c)The battery contains toxic mate- rials. Do not damage the battery case. If the case is broken or damaged, avoid contact with the battery contents.

d)Properly dispose of a damaged or worn out battery. Check with local authorities for proper dis- posal methods.

e)Do not short circuit the battery. Severe burns and fire can result.

SAFETY DECALS

Make certain all safety decals on this equipment are kept clean and in good condition. The decals are shown (at reduced sizes) below. If you need a replacement decal, please refer to the Parts Book that accompanied this Manual.

PLACE FOOT ON TIRE WHEN STARTING

WARNING

OBJECTS MAY BE THROWN FROM MOWER.

• Before mowing, clear lawn of all debris.

• Disengage wheel drive before adjusting height.

WARNING

MAXIMUM SAFE OPERATING ANGLE IS 15O.

• Exceeding maximum safe operating angle may cause tipping or loss of footing.

Do not mow on wet slopes.

Mow across slopes, not up and down

1915475.A (11/97)

CAUTION

PINCH POINTS.

Do not operate with- out all belt guards in place.

On top, rear of engine platform

4

3

 

2

LIFT FOR

1

REVERSE

N

 

R

WARNING

TO AVOID SERIOUS INJURY READ ALL SAFETY PRECAUTIONS CAREFULLY.

Read owner/operator manual.

Do not allow children or untrained adults to operate machine.

Use caution when approaching obstacles that block your view.

Keep all safety devices in place and in working order.

Do not mow when children or others are near.

Disengage wheel drive before adjusting height.

RELEASE OPERATOR PRESENCE CONTROL TO DISENGAGE MOWER.

Beneath belt/pulley

cover

On Control Panel (for electric start model)

DANGER

4

3

 

2

LIFT FOR

1

REVERSE

N

 

R

WARNING

TO AVOID SERIOUS INJURY READ ALL SAFETY PRECAUTIONS CAREFULLY.

Read owner/operator manual.

Do not allow children or untrained adults to operate machine.

Use caution when approaching obstacles that block your view.

Keep all safety devices in place and in working order.

Do not mow when children or others are near.

Disengage wheel drive before adjusting height.

RELEASE OPERATOR PRESENCE CONTROL TO DISENGAGE MOWER.

KEEP HANDS and FEET AWAY

A

On left side of

mower deck

On Control Panel (for recoil start model)

3

Image 5
Contents Model 933R Shown Operator’s ManualTable of Contents Stop the blade when crossing gravel drives, walks, or roads SafetyCleaning the mower or unclogging the chute Safe Operation Practices for Walk-Behind MowersUse only an approved container SafetyDo not mow excessively steep slopes On top, rear of engine platform Safety DecalsInspection After Delivery AssemblyUnpacking Mower Attach Handlebars to Engine DeckContents of Hardware Bag AssemblySembling Unit Control + UResult in severe personal injury or Property damageAttach Blade Drive Control Rod Attach and Adjust Gear Select LeverAttach Operator Presence Control Rod Add Motor Oil to Engine After Assembling and Before Using UnitBlade Drive Control Features and ControlsOperator Presence Control Gear Select Lever Features and ControlsWheel Drive Control Cutting Height Control LeverStart Starts engine. Release key when engine starts Ignition/Starter Switch Electric Start ModelEngine Throttle Control Engine Recoil StarterRelease all controls before adjusting the cutting height Pre-Operation ChecklistOperation Before Operating MowerStarting and Stopping Engine OperationTo Start the Engine Ignition/StarterEngaging the Blades To Stop the EngineTo Engage the Blades To Stop the BladesMowing Tips and Hints Making TurnsBlade Brake Control Test Engine OIL MaintenanceChecking Oil Level Changing OilEngine Cleaning MaintenanceAIR Cleaner Service Spark PlugBlade Spindle Belt Replacement Tipping Mower for ServiceEngine Storage Belt Cover RemovalBlade Drive Disengaged Blade Drive Engaged Blade Drive Belt ReplacementBlade Drive Belt Adjustment Blade Brake ReplacementBlade Drive Control Lever Adjustment With mower on level ground, adjustWheel Brake Adjustment Wheel Drive Belt ReplacementWheel Drive Belt Adjustment Rotate shift rod I, Figures 5-14 Follow this procedure to adjust neutral on the transmissionRemove cotter pin securing shift link P, -15 to shift rod Mower Blades Inspection/Cleaning of Mower Deck Cleaning Underside Mower DeckLubrication OFF-SEASON StorageLubrication Chart Maintenance Chart Is available from your local White Outdoor SymptomRoughly.runsEngine Overheats.EnginePage MANUFACTURER’S Limited Warranty for