Assembly
Before beginning assembly, carefully read the following information and instructions:
¥Place all parts in a cleared area and remove the packing materials from the spa shell. Do not dis- pose of the packing materials until assembly is completed and the spa is in operation.
¥During assembly, make sure that all parts are ori- ented as shown in the drawings.
¥Read each assembly step before you begin.
¥Tighten all parts as you assemble them, unless instructed to do otherwise.
ASSEMBLY REQUIRES THE FOLLOWING TOOLS (not included):
¥ One (1) phillips screwdriver
¥ You may also need some soap or water
A wire connector is provided on the pump motor of this unit to connect a minimum No. 8 AWG (804 mm2) solid copper conductor between this unit and any metal equipment, electrical enclosure made of metal, metal water pipes or conduit within five feet of the unit.
This unit is a
1.Before beginning assembly, make sure that you have read and understand the information in the box above and on the previous two pages.
Remove the four #6 x 1 1/4Ó Wood Screws (7) from the Access Cover (2). Remove the Access Cover from the spa unit by sliding it down and pulling the bottom of the Cover away from the spa unit. Make sure you donÕt damage the spa shell.
Remove the power cord with the GFCI from inside the spa unit.
1
Access Cover (2)
|
| Power Cord |
#6 x 1 1/4Ó Wood |
| |
| with (GFCI) | |
Screws (7) |
| |
|
| |
|
|
|
2. Close the valve knob on the drain hose. | 2 |
|
|
|
| Pump | |
|
|
| |
Thread the cap onto the drain hose. |
|
| Motor |
Thread the Drain Plug into the Pump Motor. |
|
|
|
Tighten the pump fittings. |
|
|
|
Drain |
|
| |
#6 x 1 1/4Ó Wood Screws (7) removed in step 1. | Plug |
|
|
|
|
| Drain |
|
|
| Hose |
|
|
| Pump |
| Cap | Valve | Fittings |
| Knob |
| |
|
|
|
8