Weslo WLHS43081 manual

Page 9

3.Wipe the spa shell clean with a damp cloth. Remove the two warning decals (not shown) from the spa shell. Before filling the spa, make sure it is in the exact position you want. Also make sure the spa can be easily serviced, if needed. Once the spa is filled with water, it must be drained to be moved.

Fill the spa by using a garden hose or other clean water source. Do not use soft water. The water temperature does not matter; however, if you use warm or hot water, the spa will be ready to use sooner. Fill the spa until the water covers the filter assembly by approximately one inch. Do not overfill the spa.

4.Attach the nozzle of the included air pump to the valve on the Inflatable Cover (4) and fill the Inflatable Cover with air. Do not overfill the Inflatable Cover.

Slide one of the straps on the inside of the Spa Cover (11) through one of the loops on the Inflatable Cover (4). Attach the latch on the strap to the buckle on the other end. Make sure the cutout on the

Inflatable Cover is lined up with the warning label on the Spa Cover. Attach the other three straps on the inside of the Spa Cover (11) through the loops on the Inflatable Cover (4) in the same manner. Place the Spa Cover (11) over the spa and line up the cutout in the Inflatable Cover with the Console.

5.See the inset drawing. Position one of the Buckles (30) on the wood panels on the spa unit. Hold the Buckle in place so the strap on the Spa Cover (11) is tight. (Note: It may be easier to position the Buckle if a second person holds the strap on the opposite side of the Spa Cover tight.) The Spa Cover must be tight. Do not place the Buckle over one of the grooves in the wood panels. Remove the latch. Attach the Buckle to the side of the spa with two #4 x 3/4Ó Screws (31). Note: It may be helpful to use a drill with a 1/16Ó drill bit to make starter holes in the wood panels. You may also want to apply a little soap or wax to the screw threads.

Attach the other five Buckles (30) to the spa unit in the same manner.

Remove the Spa Cover (11) and Inflatable Cover (4) from the spa unit.

3Fill to Here

4

 

4

Loop

 

Cutout

Buckle

 

 

Strap

 

Latch

11

 

 

Warning

 

Label

5

Strap

 

11

Latch

 

30

 

31

 

30

9

Image 9
Contents Customer HOT Line Model No. WLHS43081 Serial NoPosting the Warning Sign Table of ContentsRead and Follow ALL Instructions Important Safety InstructionsPage Page Before You Begin If you set up the hydrotherapy spa outside If you set up the hydrotherapy spa insideChoosing a Location for the Hydrotherapy Spa Do not use an extension cord with the hydrotherapy spaAssembly Page Testing and Treating the Water Using the Hydrotherapy SpaPlugging in the Hydrotherapy SPA Starting the Hydrotherapy SPASPA Operation Spa Shell DiagramSecuring the SPA Cover Without the suction covers in placeUsing the Console Console DiagramMaintenance Water Chemistry Attaching and Removing the Access CoverMaintaining the Proper PH Balance Draining the Hydrotherapy SPAFrom the pump. Note For additional protection Winter USE and CareYou can remove the pump/motor from the spa To store it in a climate-controlled roomMaintenance Notes Trouble-shooting Key No. Qty Description Part List Ñ Model No. WLHS43081Exploded Drawing Ñ Model No. WLHS43081 Ordering Replacement Parts Limited One Year Massage Spa WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT