Maintenance

Filter

Cover

Filter

Housing

The hydrotherapy spa is designed to provide you with years of enjoyment. Please follow the guidelines below to properly maintain your hydrotherapy spa.

MAINTENANCE SCHEDULE

DAILY

¥Check the water level and refill the spa to the level shown on page 9, step 3.

¥Check the pH balance and sanitizer level. Adjust if necessary (see WATER CHEMISTRY on page 14).

¥Clean the surface of the water with a skimming net.

WEEKLY

¥Clean the spa shell at the waterline.

¥Check and thoroughly clean the filter (see CHECK- ING AND CLEANING THE FILTER on this page).

¥Replace the filter if needed (see ORDERING REPLACEMENT PARTS on the back cover).

MONTHLY

¥Clean the spa cover (see MAINTAINING THE SPA COVER below).

¥Soak the filter for two hours in a trisodium phos- phate (TSP) solution. Rinse the filter in clean water.

¥Replace the filter if needed (see ORDERING REPLACEMENT PARTS on the back cover).

EVERY THREE MONTHS

¥Drain the spa and refill with clean water. Sanitize and test the pH of the water.

¥Check for any leaks around the pump or joints in the pipes. The seals will wear out over time; detect- ing leaks early can reduce repair costs.

¥Clean the interior of the spa. Do not use solvents or waxes.

EVERY SIX MONTHS

¥Treat the exterior with a wood sealant (see MAIN- TAINING THE SPA EXTERIOR below).

MAINTAINING THE SPA EXTERIOR

The wood panel exterior has been treated with a sealant at the factory to protect the wood from water damage. We suggest that you treat the wood finish twice a year with an additional coat of weather sealant. Contact your local spa and pool supplier for advice on which sealants work best in your climate.

CLEANING THE SPA SHELL

The spa shell should be cleaned with a mild soap solution. Do not use solvents. The spa should always be clean and dry before being moved or stored.

MAINTAINING THE SPA COVER

The spa cover should be cleaned monthly. To clean the spa cover, use water and a non-abrasive cleaner on the entire cover. Rinse the cover with a garden hose to remove any cleaner residue. Dry the cover entirely. You should also use a non-silicone based vinyl conditioner on the cover after you clean it. This will help protect the cover from sun damage.

SANITIZING THE HYDROTHERAPY SPA

Please refer to your local pool and spa supplier for information concerning which chemicals you should use in your area to sanitize the spa.

The most common sanitizing agent is a solid bromine concentrate. The amount required varies according to several factors, such as user load, temperature, water conditions etc.

Proper water maintenance is a fairly complex process. We recommend that you contact your local pool and spa supplier for information on how you should best accomplish this.

CHECKING AND CLEANING THE FILTER

The filter should be checked periodically for build-up of dirt and oil. If the filter needs to be cleaned, follow the steps below:

Screws

1.Turn off the power.

2.Remove the two

screws from the filter cover. Be careful not to strip the threads from the holes. Remove the filter cover.

3.Remove the filter from the spa jet

unit by lifting the filter from the filter housing.

4. Check the filter for

any dirt or debris.

If the filter needs to be cleaned,

rinse the filter with

a hose. If the filter is still dirty, you will need to soak it in a cleaning solution which can be obtained from a pool and spa supply store.

5.Inspect the filter for damage. Replace the filter if there are any signs of damage.