1.
2.Sleeve, .94 x 1.44 x 2.75 (Cat 2 Only)
3.Sleeve, .94 x 1.44 x 1.94 (Cat 1 Only)
4.Sleeve, .81 x 1.25 x 2.12
5.Sleeve, .88 x
6.3/4 Flat Washer
7.3/4 NC x
8.3/4 NC Hex Nut
9.1/2 Flat Washer
10.1/2 NC x 6 HHCS
11.1/2 NC x 2 HHCS
12.3/8 Chain,
Figure 33. Quick Hitch Kit Installation (Optional)
Install Quick Hitch (Optional)
NOTE: This kit allows mower to fit Category 1 or Category 2 standard quick hitches.
1.Lower hitch arms must be located in center attachment hole. See Figure 33 for adjustment.
2.For use with Category 1 quick hitch, lower hitch arms should be positioned with offset toward inside of mower. For use with Category 2 quick hitch, lower hitch arms should be positioned with offset toward outside of the mower.
3.Remove clevis pins from lower hitch arms. Pins will not be used for quick hitch.
4.Attach
5.Attach upper end of
(4)to
6.Remove rear offset links. They will be replaced with chains (12).
7.Attach chains (12) to top of
8.Attach opposite ends of chains (12) to rear mower frame using cap screws (11), washers (9), and flange lock nut. Vary length slightly as desired. Twist chain to make finite adjustments in length until unit lifts level.
9.Tighten all hardware.
32 Assembly | MAN0845 (1/12/2011) |
|
|