Woods Equipment Comprehensive Guide to Installing Woods Backhoes and Specifications

BACKHOE 3-POINT MOUNT INSTALLATION

TRACTOR PREPARATION

NOTE: For installing this 3-point mounting kit, refer- ence to right, left, forward and rearward directions are determined from the operator’s position in the back- hoe seat.

NOTE: Leave all hardware loose until mounting kit has been fit up.

1.Refer to the WOODS BH70X/BH80X Backhoe Operator’s Manual for backhoe assembly instruc- tions.

2.Remove the tractor top link and top link storage bracket, if equipped.

TRACTOR HIGH

STRENGTH TOP

LINK PIN

40" Minimum Radius

HEAVY-DUTY

TOP LINK

3-Pt Saf-T-Lok®	15-1/2" - 17-1/2"
Hitch Kit

*Operator’s seat must be located in the lowest and most forward position to obtain 40" minimum radius.

Figure 1. Seat Clearance

Attach Rear Brackets to Backhoe

Leave hardware loose until backhoe is attached to tractor or otherwise specified in the instructions.

14 - Nut4

16 15

1.	Attach rear brackets (4 & 5) to main frame using
	bolts (16) and hardened flat washers (15). Torque
	hardware to 297 lbs-ft.
2.	Attach mounting pins (13) to mounting brackets
	using desired hole.
3.	Secure using four (two per mounting pin) Nord
	lock washers (6) and hex nut supplied with the
	mounting pin. Do not use split lock washer sup-
	plied with hitch pin.
4.	Torque to 474 lbs-ft.

14

17

17

5

CD6779-2

4.	1012534	Right rear bracket
5.	1012535	Left rear bracket
6.	1012567	M22 Nord lock washer
13.	33661	Category 1 Mounting pin
15.	57798	5/8 Hardened flat washer
16.	735	3/4 NC x 2 HHCS GR5

Figure 2. Rear Bracket Installation

MAN0472 (9/23/2005) Installation 5