Woods Equipment BH80X, MANO472, BH70X Attach 3-Point Mount to Backhoe, Attach Backhoe to Tractor

Attach 3-Point Mount to Backhoe				8
3. Attach lock bar (7) to right (4) and left (5) rear
brackets using cap screws (9), four (two per side)
hardened flat washers (15), and hex nuts (11). Do			15
not tighten nuts at this time.
4. Swing lock bar up and attach it to the double top
link bar using cap screw (8), hardened flat washer					11
(15), and hex nut (11). See Figure 5.
4.	1012534	Right rear bracket	11	7	15
5.	1012535	Left rear bracket		15
7.	1012582	Lock bar
8.	12558	3/4 NC x 4-1/2 HHCS GR5		9
9.	13759	3/4 NC x 2-1/4 HHCS GR5
10.	14334	3/4 NC x 3 HHCS GR5
11.	1450	3/4 NC Hex nut		3
15.	57798	3/4 Hardened flat washer
				4
					CD6779-4
				Figure 5. Lock Bar Installation

Attach Backhoe to Tractor

1.Back tractor up to backhoe and 3-point mount. Center between the tractor rear tires. Position tractor so that the hydraulic system can be con- nected. Shut off tractor, set brake, and remove key.

2.Attach hydraulic pump to tractor PTO or connect hydraulic hoses.

3.With transmission in neutral, start tractor engine at idle speed and engage PTO or start hydraulic flow.

NOTE: Use the backhoe hydraulics to maneuver the 3-point mount into position. Use care in this procedure to avoid being trapped between tractor and backhoe or between backhoe parts.

4.Raise backhoe with stabilizer controls and level backhoe from side to side and front to back. Set ground clearance between 15-1/2 to 17-1/2 inches. Measure from the center of boom pivot pin to the ground. See Figure 6.

Boom

Piviot Pin

15-1/2" - 17-1/2"

CD4668

Figure 6. Ground Clearance

MAN0472 (9/23/2005) Installation 7