Cypress CY7C1510KV18, CY7C1512KV18, CY7C1514KV18, CY7C1525KV18 CY7C1510KV18, CY7C1525KV18 CY7C1512KV18, CY7C1514KV18

CY7C1510KV18, CY7C1525KV18
CY7C1512KV18, CY7C1514KV18
Document Number: 001-00436 Rev. *E Page 15 of 30
TAP Controller Block Diagram
TAP Electrical Characteristics
Over the Operating Range [10, 11, 12]
Parameter Description Test Conditions Min Max Unit
VOH1 Output HIGH Voltage IOH = −2.0 mA 1.4 V
VOH2 Output HIGH Voltage IOH = −100 μA1.6 V
VOL1 Output LOW Voltage IOL = 2.0 mA 0.4 V
VOL2 Output LOW Voltage IOL = 100 μA0.2V
VIH Input HIGH Voltage 0.65VDD VDD + 0.3 V
VIL Input LOW Voltage –0.3 0.35VDD V
IXInput and Output Load Current GND ≤ VI ≤ VDD –5 5 μA
0
012..29
3031
Boundary Scan Register
Identification Register
012..
.
.108
012
Instruction Register
Bypass Register
Selection
Circuitry
Selection
Circuitry
TAP Co ntro lle r
TDI TDO
TCK
TMS
Notes
10.These characteristics pertain to the TAP inputs (TMS, TCK, TDI and TDO). Parallel load levels are specified in the Electrical Characteristics table.
11.Overshoot: VIH(AC) < VDDQ + 0.85V (Pulse width less than tCYC/2), Undershoot: VIL(AC) > −1.5V (Pulse width less than tCYC/2).
12.All voltage referenced to Ground.
[+] Feedback