Remove Backhoe
The only time the backhoe may be operated from a position other than the operator seat is during backhoe attachment and removal. Opera- tor must
•Read Mounting Kit Manual instructions on attaching and removing backhoe and use extreme care.
•Always stand between rear tire and back- hoe stabilizer arms or along side of tractor to avoid being trapped should the boom swing control be accidentally activated.
1.Remove the seat assembly.
2.Start the tractor. Engage hydraulics at slow idle speed. Curl the bucket all the way towards the operator.
3.On a hard level surface, center the boom, remove transport lock bar, and extend boom and dipper- stick.
4.Rest bucket on the ground and lower stabilizers to take backhoe weight off tractor.
5.Remove
6.Remove lower
7.Place 6" blocks under backhoe mainframe and raise stabilizers to lower the backhoe onto the blocks as shown in Figure 9. Adjust blocks to make backhoe stable.
8.Disengage PTO, turn off engine, set brakes, and remove key before leaving tractor seat.
9.Remove the backhoe hydraulic pump from the PTO shaft or disconnect hydraulic hoses from tractor.
10.Start tractor and drive the tractor away.
11.Reinstall seat assembly.
|
|
|
BH1 | 6" Blocks |
|
|
| |
|
|
|
Figure 9. Backhoe Storage Position (Typical)
Store Hydraulic Pump (If Equipped)
Store pump on back side of backhoe to prevent dirt and debris from accumulating in pump adapter.
MAN0472 (9/23/2005) | Installation 9 |
|
|