S E R V I C E A N D M A I N T E N A N C E
Important!
Check the bolts on the following for correct torque (75 ft. lbs.) every
10 hours of operation:
•Hydraulic feed roller bearing
•Hydraulic motor mounting
•Chipper rotor bearing
•Chipper blades
•Rotor paddles
•Chipper anvil
Warning: Failure to maintain proper fastening torque (75 ft. lbs.) on bolts for the components listed above may result in severe damage to the chipper and/or personal injury!
GreaseableBearings
The PTO model has ten grease zerks. Minimal periodic greasing is needed on these points every 50 hours:
•Four grease zerks on the PTO shaft itself.
•Two greaseable bearings on the rotor shaft.
•Two greaseable bearings on the bottom jack shaft.
•One idler arm pivot
•One discharge chute
18