Woods Equipment 8000, 8100 manual Install the 6.6 Pulley, Mount the Hydrostatic Pump

H Y D R A U L I C F E E D I N S T A L L A T I O N

Install the 6.6" Pulley

1.Remove the chipper drive belt guard.

2.Put the 6.6" pulley on the rotor shaft end.

3.Place the 1.75" bushing on the rotor shaft and put the 3/8" x 1/4" key into the bushing slot. Do not tighten the bushing yet.

Mount the Hydrostatic Pump

1.Attach the pump control arm to the pump control on the hydrostatic pump with two 1/4" x 1/2" bolts.

2.Mount the pump mount bracket to the hitch weldment by inserting two 3/8" x 1-1/2" bolts through the bolt holes. Place the cable attachment angle over the bolt ends on the other side of the hitch weldment. Secure the bolts with two 3/8" washers and nuts.

3.Slide the 4" pulley over the pump shaft. Slide the 15mm bushing next to the pulley. Place the 5mm x 25mm key into the bushing. Do not tighten the bushing yet.

Connect the Hydrostatic Cable

1.Insert the hydrostatic control cable end (the end without nuts attached) through the cable hole in the hitch weldment.

Figure9

Roller

Assembly

Hydrostatic

Motor

Crossover

ReliefValve

PN-51210 (Rev. 7/98)

20