Swisher ZT2560 manual Deck Lifting System

Page 13

DECK LIFTING SYSTEM

Three rocker arms are activated by the deck lift handle. This is the right side control. Note the routing of the cable. It drops straight below to the deck.

This center rocker arm lifts the front center of the deck. It also drops through the lower frame but is directed by two pulleys under the mower frame to the front of the deck.

The deck lift system has two springs to assist in raising the deck. The ease of lifting the deck can be adjusted by tightening this nut equally on each spring.

The guide pulley for the front center deck lift cable.

Front guide pulley for the center lift cable.

To level the deck, start by lowering the deck lift handle to its lowest position. If the deck is not setting on the ground, turn the nuts under these three brackets until it does. The left and right cables in the rear should then be tightened until the back end of the deck is level across and rides about 1\4 inch higher than the front end.

11

Image 13
Contents Repair Manual Table of Contents Always Check Fuse First Test #1 If Engine WON’T CrankTest #2 Test #3Page Engine Cranks but WON’T Start Engine Stalls When PTO is EngagedHour Meter not Operating If PTO Clutch will not EngagePTO Switch Plug Wire Identification AT Switches Ignition SwitchStarter Solenoid Wiring Harness Plug to Engine Wiring Harness to Engine Plug ConnectionCarburetor Fuel Solenoid Battery Charging SystemLeft Side Shown Drive Control AdjustmentsRight Side Shown Overview of Drive Control LinkageParking Brake and Neutral Switch Operation Deck Lifting System Engine to Deck Belt Deck Belt ReplacementDeck Cross Belt Repairing or Replacing Blade Driver