A |
|
Deck |
|
Stabilizer | Deck |
| |
| Stabilizer |
Cross Bar | Diagonal |
| Brace |
B |
|
46" |
|
50" |
|
Spacer |
|
C |
|
Spacer |
|
| Place Spacer |
| Here |
D |
|
Spacers | |
Figure 8
•Place a spacer on the left end of the cross bar. Pull the bar to the right until the spacer is flushed with the end of the bar as shown in Figure 8B. Lift assembly and slide the cross bar into one of the holes on the left side of frame. Secure with hairpin
clip removed in step 6.
46" Deck: Use the rear set of holes.
50" Deck: Use the forward set of holes.
•Place a spacer on the right end of the cross bar. Pull the bar to the left until the spacer is flushed with the end of the bar. Slide the cross bar into the hole on the right side of frame. Secure with hairpin clip. See Figure 8D.
•Move the lift lever forward to the lowest position.
NOTE: It may be necessary to pull down on the lift links to obtain the lowest position.
•Lift up on the edge of the deck and hook up the left front deck hanger to the deck using a flat washer and hairpin clip. Make sure deck hanger goes through the center of
Hanger Brackets
Belt
Figure 9
•Attach the right front hanger to the deck using a flat washer and hairpin clip.
•Move the lift lever all the way back to the full raised position.
•Units with 50" Decks: Remove the clevis pins and hairpin clips from the roller assembly. Slide the roller assembly between the rear wheels and the deck. Insert the deck roller brackets up through the brackets provided on the rear of the deck. It may be necessary to rotate the deck roller brackets 360° to clear the roll pin stop. Attach with clevis pins and hairpin clips just removed, using the lowest hole location on each side of the deck. See Figure 10.
•Move the lift lever forward to the lowest position.
•Attach the two rear lift links with flat washers and hairpin clips.
•Place deck belt around the engine pulley. Make certain the deck belt is seated in the deck pulley.
12