Guardian® Tilt Automatic Overbed Table
User Instructions
Model
POSSIBLE DAMAGE OR INJURY. Be alert of hi/lo adjustment of overbed table when raising bed.
ASSEMBLY INSTRUCTIONS (FIGURE 1)
1.Using the hex bolts and washers, attach the base to the post. Tighten the bolts securely.
2.Insert the tilt control bar into the post by loosening post screw. Tighten post screw, once tilt control bar has been inserted into post.
3.Attach the outer tube to the top board using the screws.
4.Slide the outer tube onto the tilt control bar. If it is too tight, release the rotating knob on the tilt control bar.
5.Tighten the rotating knob to set the top board.
6.Insert the casters into the base until they lock into place.
Tilt Control Bar |
|
Rotating Knob | Top Board |
| |
Post Screw |
|
| Outer Tube |
| Screws |
| Base |
Hex Bolts | Casters |
Figure 1