Areas of USE, THROTTLE/CHOKE Control | Stiga 8211-0288-01 instruction

ENGLISH	GB

Make sure that the parking brake is released when driving.

4. DRIVE PEDAL (President - Royal)

Pedal which activates the variable transmission.

1.Press down the pedal with the ball of your foot – the machine moves forwards.

2.No pressure on pedal – the machine is stationary.

3.Press down the pedal with your heel – the machine reverses.

The speed is regulated with the drive pedal. The more pressure applied on the pedal, the faster the machine goes.

5. THROTTLE/CHOKE CONTROL

Control for setting the engine speed and to choke the engine for cold start.

1.Choke – for starting a cold engine. The choke is located in the top of the groove.

2.Full throttle – when the machine is in operation, full throttle should always be used.

3.Idling.

6.IGNITION LOCK

Ignition lock used to start and stop the engine. Four positions:

1.Stop position – the engine is short- circuited. The key can be removed.

2/3. Operating position.

4.Start position – the electric start motor is activated when the key is turned to the spring-loaded start position. Once the en- gine has started, let the key return to oper- ating position 2/3.

7.GEAR LEVER (Master - Senator - Comfort)

Lever for selecting one of five forward gears in the gearbox (1-2-3-4-5), neutral (N), or reverse (R).

The clutch pedal must be depressed when chang- ing gear.

NOTE! Make sure that the machine is standing completely still before changing from reverse to forward gear, or vice versa. If a gear does not en- gage immediately, release the clutch and then press it in again. Engage the gear again. Never force a gear in!

8. POWER TAKE-OFF

Switch for engaging and disengaging the electro- magnetic power take-off for driving front-mounted accessories. Two positions:

1.Press in the right side of the switch – the power take-off engages. The symbol lights up.

2.Press in the left part of the switch – the power take-off disengages.

9.DISENGAGING LEVER (President - Royal)

Lever for disengaging the variable transmission. Enables the machine to be moved by hand without using the engine. Two positions:

1.Lever pressed in – the trans- mission is engaged for normal use.

2.Lever pulled out – the trans- mission is disengaged. The ma- chine can be moved by hand.

The machine must not be towed long distances or at high speed. This can damage the transmission.

AREAS OF USE

The machine must only be used for the following tasks with the indicated STIGA original accessories:

1.Mowing

With mower deck 13-2929 (92M) or 13-2930 (107M).

2.Grass clippings and leaves collection

With towed collector 13-1978 (30") or 13-1950 (42").

3.Grass and leaves transport

With dump cart 13-1979 (Standard), 13-1988 (Maxi) or 13-1992 (Combi).

ENGLISH