Low Frequency Column (Upper Section). Refer to fig- ure 3.
3. Carefully push together the two Low
Lower Woofer
Column
Openings for pins
Figure 3
Frequency Columns (Lower and Upper Sections).
4.Using the socket tool, tighten the four hex head bolts until the Low Frequency Column (Lower and Upper Sections) is pulled together with no space between the two sections.
Final Assembly of the Loudspeaker
1.Locate the previously removed protective blue cloth covers and drape them over the top of the Low Fre-
quency Column (Lower and Upper Sections), to tempo-
Blue protective cloth covers
Figure 4
rarily protect the Woofers. Refer to figure 4.
2.Place four pieces of foam packing material removed from the Midrange/High Frequency Column Shipping Carton, on top of the cloth covers placed in step 1. Re-
fer to figure 5.
End piece of foam
Center pieces of foam
Figure 5
3.Locate the Midrange/High Frequency Column and place it on top of the foam packing material placed in step 2, making sure the end with the draw cords is placed near the base end of the Low Frequency Column and the Grille is facing upwards. Refer to figure 6.
Socket and Cable | Midrange/Tweeter Column in cloth cover | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Figure 6
4.Untie the cloth cover draw cords on the Midrange/High Frequency Column and push up the cover about six inches (15.24cm). Using the supplied “T” handle tool remove the hex head screws from the bottom of the col- umn. These screws will be used later to fasten the Col- umn to base in step number 8. Refer to figure 8.
5.Locate the cable coming from inside the Low Frequency Column base and orient it to match up with the socket located on the rear of the Midrange/High Frequency Column.
6.Insert the plug into the socket and rotate the locking col- lar clockwise until it is finger tight.
7.Remove the end piece of foam, leaving the three center pieces of on top of the Low Frequency Column. Refer to figure 5. Then reposition the bottom of the Midrange/ High Frequency Column to fit into the channel opening of the Low Frequency Column base. Refer to figure 7.
Figure 7
8.Using the previously removed hex head screws and “T” handle tool, fasten the Midrange/High Frequency Col- umn to the metal plate part of the Low Frequency Col- umn base. Refer to figure 8.
9.Position the Loudspeaker System upright rest-
ing on its base.
Note: Do not lift up |
|
on the |
|
Midrange/ |
|
High |
|
Frequency | Figure 8 |
Column. |
10. Remove the three center foam packing materials and
the three protective blue cloth covers.
11.Remove the protective blue cloth cover from the Low Frequency Column Grille and attach the Grille to the Low Frequency Column.
10