Shindaiwa 81010 Install the Cutting Attachment Shield T272/T272X, Assembly and Adjustments

Assembly and Adjustments

Cutting Attachment Shield

Socket-				T272	T272X
Head Cap
Screw					Bolt
			Outer
			Tube	Cutting	Upper Clamp
Bracket				Attachment
				Shield
					Shim
Shim
Clamp					Nuts
Screw
				Line Cutter	Shim
			Shim		Nut
		Cutting			Cutting Attachment Shield
	Retaining	Attachment
23105		Shield	Hex
	Nut	Mounting
			Screws
		Plate		Figure 8A
Figure 8

Install the Cutting Attachment Shield T272/T272X.

1.Insert the cutting attachment shield between the outer tube and the cutting attachment shield mounting plate. See Figure 8.

NOTE: Bracket

It may be necessary to loosen the retaining nut and clamp screw to adjust cutting attach- ment shield mounting plate.

WARNING!

NEVER operate the unit without the cutting attachment shield installed and tightly secured!

Sub-Shield T272X.

(when trimmer head is in use)

1. Attach the shield extension to the

cutting attachment shield.

Cutting Attachment Shield

Hook

Receiver

2. Fit the two shims and the bracket over

Sub-shield

Hook

the outer tube and loosely install the

four socket-head cap screws. See

Figure 8.

3. Tighten the four socket-head cap screws

to secure the cutting attachment shield.

CAUTION!

Make sure the clamp screw and retaining nut are securely tightened before tightening the four socket-head cap screws.

WARNING!

NEVER use this machine without sub-shield when using a trimmer head.

CAUTION!

Make sure the sub-guard is completely hooked at the hook receiver.

To Change Position of Line Cutter.

The line cutter can be positioned in

2 positions to obtain different line length for cutting.

1.Remove the 2 hex screws with a 4mm hex wrench. See Figure 8A.

WARNING!

The line cutter is very sharp. Wear gloves to protect your hands when handling.

2.Rotate line cutter. See Figure 8A.

3.Reinstall the two hex screws and tighten them securely.

NOTE:

Be careful to not lose the 2 nuts in the cutting attachment shield, they are not captured.

7