Servis-Rhino 5211 manual Detaching Quick Attach Device, Assembling Quick Attach Device

ASSEMBLY

Detaching Quick Attach Device

To avoid injury during installation of the loader attachment, do not allow bystanders within 10 feet of loader or attachment.

1.Locate tractor and loader can level ground.

2.Lower boom arms until the attachment is level and resting on ground.

3.Place tractor in neutral, set parking brake, shut off tractor engine and disengage quick attach device latch pins by moving handles to unlatch position (refer to Figure Asm-L-0039).

4.Start tractor engine, release brake and extend bucket cylinders while slowly backing the tractor away from attachment, until quick attach disengages from attachment.

Assembling Quick Attach Device

Quick attach device can be installed using tools ordinarily available. Torque all hardware to specifications listed in loader operator’s manual. Shut off the tractor engine and engage the tractor brakes during installation.

Only quick attach, skid steer compatible attachments can be used with the quick attach device. Pin on style attachments can be used on the loader, but necessitate removal of the quick attach device and relocation of the bucket level indicator.

All references to left and right used in these instructions are as they would appear to the operator standing at the rear of the unit facing forward.

1.Quick attach device is pre-assembled at the factory.

2.Unband the quick attach device and wood blocks. (Figure Asm-L-0012)

ASSEMBLY

5211 01/11 Assembly Section 3-9

© 2011 Alamo Group Inc.