Sunbeam FA7500 manual Safety Precautions For Your Tower Fan

Page 4

Safety Precautions For Your Tower Fan

Do not use outdoors.

Do not run the cord of the fan under carpeting. Do not cover the cord with throw rugs, runners or other floor coverings. Arrange the cord away from traffic areas so that it will not be tripped over.

Do not use this fan in the immediate surrounds of a bath, shower, laundry area or swimming pool.

Be sure the fan is placed on a dry, even surface. Do not use on soft surfaces, such as beds, where opening may become blocked.

Keep your fan away from heat sources, corrosive gases and avoid direct sunlight.

This fan is only to be used with the base fitted and in good condition.

Disconnect the power plug before dismantling, assembling or before cleaning.

Always unplug the fan when not in use for any long length of time.

The fan must not be used if the guards are damaged in any way.

Do not insert or allow foreign objects to enter any ventilation or exhaust openings as this may cause electric shock or fire, or damage to the fan.

Never insert fingers, pencils or any other objects through the guards whenever the power plug is connected, especially while running.

Avoid touching mobile parts of the fan.

Do not attempt to move your fan whilst it is operating. If your fan needs to be moved, please ensure that it is turned off and you use the carry handle on top of the tower.

When scrapping the fan at the end of its useful life, follow local regulations.

Important Instructions - Retain For Future Use

If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood.

2

Image 4
Contents Sunbeam Brushed Remote Control Tower Fan Contents Sunbeam’s Safety Precautions Safety Precautions For Your Tower Fan Important Instructions Retain For Future UseLocating Your Tower Fan Always locate your fan on a flat level surfaceFeatures Of Your Sunbeam Tower Fan Remote control storagePower button Carry handleNature mode Remote controlFan speed button Auto Off buttonRemove the screws from beneath the tower Assembling Your Tower FanLower the tower onto the base Screw the tower to the base Clip the cord into placeUsing Your Tower Fan Switching the fan onSwitching the fan off Selecting a fan speed settingUsing the remote control Changing the batteriesUsing the auto off timer Using the oscillation functionPress the button on either the fan or Remote. Troubleshooting Guide Care And CleaningIf your remote control fails to operate check the following If your tower fan fails to operate check the followingYear Replacement Guarantee Sunbeam Service CentresAustralia New ZealandConsumer Hotline