Sunbeam FA7500 manual Screw the tower to the base, Clip the cord into place

Page 9

Assembling Your Tower Fan (continued)

Screw the tower to the base

Use the 6 screws you put aside earlier to secure the tower to the base.

Clip the cord into place

1.Feed the cord along the channel underneath the base.

2.Screw the cord into the edge of the base using the two screws provided.

3.Stand the fan upright. It is now ready for use.

7

Image 9
Contents Sunbeam Brushed Remote Control Tower Fan Contents Sunbeam’s Safety Precautions Important Instructions Retain For Future Use Safety Precautions For Your Tower FanAlways locate your fan on a flat level surface Locating Your Tower FanRemote control storage Features Of Your Sunbeam Tower FanPower button Carry handleRemote control Nature modeFan speed button Auto Off buttonAssembling Your Tower Fan Remove the screws from beneath the towerLower the tower onto the base Clip the cord into place Screw the tower to the baseSwitching the fan on Using Your Tower FanSwitching the fan off Selecting a fan speed settingChanging the batteries Using the remote controlUsing the oscillation function Using the auto off timerPress the button on either the fan or Remote. Care And Cleaning Troubleshooting GuideIf your remote control fails to operate check the following If your tower fan fails to operate check the followingSunbeam Service Centres Year Replacement GuaranteeAustralia New ZealandConsumer Hotline