MTD 607 Stopping the Engine, Driving the Tractor, Driving on Slopes, Operating the Headlights

Page 12

NOTE: Do NOT leave the choke control out while operating the tractor. Doing so will result in a "rich" fuel mixture and cause the engine to run poorly.

STOPPING THE ENGINE

•Place the PTO lever in the disengaged (OFF) position

•Move the throttle control into the SLOW (turtle) position and allow the engine to "idle down" for ten seconds. Failure to do so may result in an engine afterfire.

•Turn the ignition key counterclockwise to the OFF position.

•Remove the key from the ignition switch to prevent accidental starting.

IMPORTANT: If you think you’ve struck a foreign object, stop the engine immediately. Remove the wire(s) from the spark plug(s), thoroughly inspect the unit for any damage, and repair the damage before restarting and operating the tractor.

DRIVING THE TRACTOR

WARNING: Avoid sudden starts, excessive speed and sudden stops.

WARNING: Do not leave the seat of the tractor without first placing the PTO lever in the disengaged (OFF) position, depressing the brake pedal and engaging the parking brake. If leaving the tractor unattended, also turn the ignition key off and remove the key.

•Depress the brake pedal to release the parking brake and let the pedal up. Move the throttle lever into the FAST (rabbit) position.

IMPORTANT: Do NOT use the shift lever to change the direction of travel when the tractor is in motion. Always use the brake pedal to bring the tractor to a complete stop before shifting.

•To move forward, place the shift lever in the FORWARD position, then slowly depress the drive pedal until the desired speed is achieved.

•To move in reverse, place the shift lever in the REVERSE position, check that the area behind is clear then slowly depress the drive pedal.

DRIVING ON SLOPES

Refer to the SLOPE GAUGE on page 6 to help determine slopes where you may not operate safely.

WARNING: Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). The tractor could overturn and cause

serious injury.

Operate the tractor up and down slopes, never across slopes. Do not drive so that the tractor may tip over sideways.

Before operating the tractor on any slope, walk the slope to look for possible hazards such as rocks. mounds, ruts, stumps or other surface irregularities which could cause the tractor to be upset.

Avoid turns when driving on a slope. If a turn must be made, turn down the slope. Turning up a slope greatly increases the chance of a roll over.

Avoid stopping when driving up a slope. If it is necessary to stop while driving up a slope, start up smoothly and carefully to reduce the possibility of flipping the tractor over backward.

OPERATING THE HEADLIGHTS

To turn the tractor’s headlights on:

•Start the engine following the instructions earlier in this section.

•Turn the key one notch counterclockwise into the On/Lights position of the ignition switch.

Refer to Figure 4.

To turn the tractor’s headlights off:

•Turn the key either into the On position (to leave the engine running) or the Off position (to shut the engine off). Refer to Figure 4.

IMPORTANT: Never move the key into the Start position while the engine is running. Doing so may cause damage to your engine’s starter.

STOPPING THE ENGINE

•Place the PTO lever in the disengaged (OFF) position.

•Move the throttle control into the SLOW position and allow the engine to "idle down" for ten seconds, then turn the ignition key counterclockwise to the OFF position.

•Remove the key from the ignition switch to prevent accidental starting.

IMPORTANT: If you think you’ve struck a foreign object, stop the engine immediately. Remove the wire(s) from the spark plug(s), thoroughly inspect the unit for any damage, and repair the damage before restarting and operating the mower.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Important Read Safety Rules and Instructions Carefully OPERATOR’S ManualTable of Contents Finding Your Model NumberMTD Products INC Calling Customer SupportImportant Safe Operation Practices General OperationService Slope OperationDo not ChildrenSafety Labels found on your unit Slope Gauge USE this page AS a Guide toAttachments & Accessories Attaching the Battery CablesTractor SET-UP GAS and OIL FILL-UPControls Ignition Switch Systems Indicator MonitorThrottle Control Lever Choke ControlPTO Power TAKE-OFF Lever Lift LeverDrive Pedal Parking Brake ButtonSafety Interlock Switches Setting the Cutting HeightOperation Starting the EngineStopping the Engine Driving the TractorDriving on Slopes Operating the HeadlightsAdjustments Using the Lift LeverEngaging the PTO Power TAKE-OFF Lever MowingSeat Adjustment Side to SideFront to Rear Side to Side Brake Adjustment Steering AdjustmentMaintenance Carburetor AdjustmentCleaning the Engine and Deck EngineCutting Deck Removal LiftFront of Tractor Changing the Deck Belts Inch decksChanging the Transmission Drive Belts Upper Drive BeltLower Drive Belt Cutting Blades Lubrication Troubleshooting Guide Trouble Possible Corrective Action CausesModels 607, 608 Part DescriptionElectrical System Green BlueModels 607 Tractor Body Model Dash Panel Models 607, 608 Lift Assembly 3126 Steering Assembly 4413 Drive System 31 30 12c Single-speed Transmission Hook spring, Ref , here PTO belt for 42 deck shown Power Take-off System Inch Deck Brake Assembly Cutting Decks Briggs & Stratton OHV V-Twin Engine Accessories Briggs & Stratton Opposed TwinMANUFACTURER’S Limited Warranty

607 specifications

The MTD 607 is an advanced piece of machinery designed for a variety of agricultural and landscaping applications. Known for its robust performance and durability, the MTD 607 stands out due to its careful engineering and innovative technologies that cater to the needs of modern users.

One of the key features of the MTD 607 is its powerful engine. This model typically boasts an engine with high torque output, providing the necessary strength for tackling tough terrain and dense vegetation. This allows users to perform a wide range of tasks, from mowing larger areas to managing challenging landscapes efficiently. Its engine is not only powerful but also designed to be fuel-efficient, ensuring that users can rely on the machine for extended periods without frequent refueling.

The MTD 607 incorporates cutting-edge technology to enhance user experience and improve productivity. For instance, it features an intuitive control panel that puts all necessary functions at the operator's fingertips. This means operators can easily adjust settings, monitor performance, and manage tasks without having to navigate through complicated systems. Additionally, some models include digital displays that provide real-time feedback regarding speed, operating hours, and maintenance requirements, ensuring optimal performance at all times.

Comfort is another important aspect of the MTD 607. The design prioritizes ergonomic features, featuring adjustable seats and easy-access controls that cater to users of all sizes. This focus on comfort helps reduce fatigue during prolonged use, allowing operators to work more efficiently over longer periods. Moreover, the MTD 607 is built with a sturdy frame and reinforced components that contribute to its longevity, making it a reliable choice for both commercial and residential users.

Safety is paramount in the design of the MTD 607. It includes multiple safety features such as automatic shut-off mechanisms, reinforced guards, and intuitive braking systems. These features work together to provide peace of mind for operators, ensuring safe operation even in challenging conditions.

In conclusion, the MTD 607 is a versatile and powerful machine with a range of features that make it suitable for various applications in agriculture and landscaping. From robust engines and user-friendly technology to ergonomic designs and safety enhancements, it provides an excellent solution for those seeking efficiency and reliability in their outdoor tasks. Whether for professional landscaping services or personal gardening efforts, the MTD 607 is a worthy investment for enhancing productivity and achieving excellent results.
Top Page Image Contents