Unpacking and Placement

1.Once the box is opened and top layer of foam removed, the following items will be visible:

1 KPS-30i

1 KPS-30i Remote Control

1KPS-30i Custom CD clamp

1AC power cord

1Packet containing the Owner's Reference and Warranty

Registration Card

NOTE: If any of these items are not included, please contact your authorized dealer immediately for assistance.

2. Carefully remove the unit and accessories from the box. Remove the protective plastic wrap from the unit.

NOTE: Save all packing materials. If you must ship your KPS-30i in the future, repack the unit in its original packaging to prevent transit damage. KRELLis not

responsible for damage incurred during the shipment of goods without factory approved packing material.

PLACEMENT

Before you install the KPS-30i into your system, we recommend that you

follow these guidelines in choosing the location. This .will facilitate a clean,

trouble-free installation. The KPS-30i does not require any type of special rack

or cabinet for installation. Dimensions are described on page 17.

1.Place the unit on a firm level surface away from excessive heat, humidity or moisture. Make sure there is enough room at the top for a compact disc to be placed within the chassis. Approximately ten inches is necessary.

2.Although well shielded, the KPS~30i should not be placed in close proximity

to hum sensitive components such as preamp phono stages or turntables.

The power supply may create interference and induce hum..~

3.The KPS-30i incorporates an advanced suspension system and does not

require	additional	mass coupling or isolation.	You may experiment with feet or
cones	as long as	they don't permanently affix	to the chassis. Any unauthorized

modifications to the electronics or chassis will void the warranty.