Multiquip ONE-WAY PLATE COMPACTOR manual Inspection and Maintenance ServiceTables

MAINTENANCE

CAUTION

Inspection and other services should always be carried out on hard and level ground with the engine shutdown.

Inspection and Maintenance ServiceTables.

1.To make sure your plate compactor is always in good working condition before using, carry out the maintenance inspection in accordance with Tables 4 through 6.

TABLE 4. MACHINE INSPECTION

Item	Hours of Operation	Remarks
(Starting check)	Every 8 hours (every
	day)
Loosened or lost	Every 8 hours (every
screws	day)
Damage of any part	Every 8 hours (every
	day)
Function of controlling	Every 8 hours (every
system part	day)
Vibrator oil check	Every 100 hours	See page 19.
Vibrator oil	Every 200 hours	See page 19.
replacement
V-belt (clutch) check	Every 200 hour	See page 19.

TABLE 5. ENGINE CHECK

(For details, see separate Engine Manual)

Item	Hours of Operation
Leakage of oil or fuel	Every 8 hours (every day)
Tightness of fastening threads	Every 8 hours (every day)
Engine oil check and	Every 8 hours (every
	day)(Replenish to specified max.
replenishment
	level)
Engine oil replenishment	At first 20 hours, then every 100
	hours
Air cleaner cleaning	Every 50 hours

CAUTION

These inspection intervals are for operation under normal conditions. Adjust your inspection intervals based on the number hours plate compactor is in use, and particular working conditions.

CAUTION

Fuel piping and connections should be replaced every 2 years.

Daily Service

Check for leakage of fuel or oil.

Remove soil and clean the bottom of compaction plate.

Check engine oil, see page 13.

Check for loose screws including tightness. See Table 6 below (tightening torque ), for retightening:

TABLE 6.

TIGHTENING TORQUE (in. kg/cm) Diameter

Material	6mm	8mm	10mm	12mm	14mm	16mm	18mm	20mm
4T	70	150	300	500	750	1,100	1,400	2,000
6-8T	100	250	500	800	1,300	2,000	2,700	3,800
11T	150	400	800	1,200	2,000	2,900	4,200	5,600

*100 (6mm) 300 ~ 350 (8mm) 650 ~ 700 (10mm)

*(In case counter-part is of aluminum)

(Threads in use with this machine are all right handed)

Material and quality of material is marked on each bolt, and screw.

Engine Oil Replacement:

1.Replace engine oil, in first 20 hours of operation and every 100 hours afterwards.

2.Oil may be drained more easily when it is warm after operation (For more details, see separate HONDA or ROBIN Owner's Manual).

3.When changing the engine oil, thenold oil can be drained by removing the oil filler cap, and un-screwing the engine oil drain plug located at the base of the engine.

4.Remember to refill engine crankcase with the recommended type of oil as listed in Table 3.

PAGE 20 — MVC77 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #4 (1/14/11)