INSPECTION
V-Belt Check
CAUTION
NEVER attempt to check theV-belt with the engine running. Severe injury can occur of your hand (Figure 6) gets caught between theV-belt and the clutch.Always use safety gloves.
2.The V-belt tension is proper if the V-belt bends 10 to 15 mm (Figure 8) when depressed with finger at midway between the clutch and vibration pulley shafts.
CLUTCH
PULLEY
VIBRATOR
PULLEY
Figure 6.V-Belt Hazard
1.To check the V-belt tension, remove the three bolts that secure the belt cover to the frame as shown in Figure 7.
Figure 8.V-Belt Tension
3.A loose V-belt will decrease the power transmission output, causing reduced compaction and premature wear of the belt.
4.If the V-belt becomes worn or loose, replace it by using V- belt part number 070503350.
Figure 7.V-Belt Cover Removal
PAGE 16 — MVC77 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #4 (1/14/11)
