Multiquip operation manual DCA-56SPX Generator SHUT-DOWN Procedures, Normal Shutdown Procedure

DCA-56SPX — GENERATOR SHUT-DOWN PROCEDURES

WARNING - SHUTTING DOWNTHE GENERATOR

NEVER stop the engine suddenly except in an emergency.

Normal Shutdown Procedure

To shutdown the generator use the following procedure:

1.Place both the MAIN, GFCI and LOAD circuit breakers as shown in Figure 39 to the OFF position.

2.Let the engine cool by running it at low speed for 3-5 minutes with no load applied.

3.Place the MPEC Control Switch (Figure 42) to the OFF/RESET position.

Figure 42. MPEC Control Switch (Off/Reset)

4.Verify that the all status LED on the MPEC display are OFF (not lit).

5.Remove all loads from the generator.

6.Inspect entire generator for any damage or loosening of components that may have occured during operation.

Emergency Shutdown Procedure

1.Place the MPEC Control Switch switch (Figure 42) to the OFF/RESET position.

2.To shut-down the engine in the event of an emergency, switch the MAIN, GFCI and LOAD (Figure 39) circuit breakers to OFF position.

PAGE 38 — DCA-56SPX— OPERATION AND PARTS MANUAL — REV. #1 (04/22/10)