English
!9Record (REC) Selector Switch
Use this switch to select recording between the tape deck and
@0Source Direct Switch
Press this switch to turn source direct on (depressed) and off (raised).
When source direct is turned on, the audio signal path is as short and direct as possible in order to enjoy
NOTE:
Tape and
@1Bass and Treble Tone Controls
Use these controls to control the levels of their corresponding frequency bands. TREBLE adjusts the high frequency band, while BASS adjusts the low frequency band. Rotating a control towards (+) enhance the frequency band, while rotating towards
@2Seaker Switches 1/2
Use these switches to turn speaker output on (depressed) and off (raised). You can turn off speaker output when listening to output over headphones.
@3Phones Jack
Use the jack to plug in headphones that are equipped with a standard phone jack.
@4Standby Indicator
This indicator is lit while the amplifier is in the Standby Mode. Pressing the remote control unit’s POWER buttons switches the amplifier between standby and power on.
OPERATION
| 1 |
|
|
|
|
|
|
|
|
|
|
| 3 |
|
| INTEGRATED AMPLIFIER PM7000 |
|
|
|
|
|
|
|
|
|
| |
INPUT SELECTOR |
|
|
|
|
|
|
|
|
| VOLUME | |||
|
|
|
| TAPE | PHONO | CD | TUNER | AUX1 | AUX2 |
|
|
| |
|
|
|
| TAPE |
|
| MUTE |
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| MIN |
| MAX |
|
|
|
| REC SELECTOR |
| BASS |
|
| TREBLE |
|
| BALANCE | |
POWER ON/OFF | PHONES | STANDBY | 1 SPEAKERS 2 | OFF |
|
|
|
|
|
| SOURCE DIRECT |
|
|
SOURCE | TAPE |
|
|
|
|
|
| ||||||
|
|
|
|
| TAPE |
|
|
|
|
|
|
| |
|
|
|
|
| COPY |
|
|
|
|
|
|
| |
|
|
| ON OFF |
|
|
| - | + | - | + | ON OFF | L | R |
3
2Perform the applicable operation on the connected equipment.
TO PLAY AN ANALOG RECORD
1.Set INPUT SELECTOR to PHONO.
2.Play the record on the turntable.
3.Use VOLUME to adjust volume, and BASS and TREBLE to adjust the tone.
NOTE:
•Be sure the set VOLUME to is minimum setting before placing the stylus onto the record or before replacing the turntable’s cartridge.
•Never subject the turntable to shock or vibration while a record is playing. This can cause the stylus to jump and possible damage the record.
•Locating your turntable too close to the speakers can cause howling, which will make it impossible to use higher volume settings.
•Never turn off power while the stylus is in contact with the surface of the record.
TO LISTEN TO AN FM/AM BROADCAST
1.Set INPUT SELECTOR to TUNER.
2.Tune in the desired station on the tuner.
3.Use VOLUME to adjust volume, and BASS and TREBLE to adjust the tone.
TO PLAY A COMPACT DISK
1.Set INPUT SELECTOR to CD.
2.Play a CD on the CD player.
3.Use VOLUME to adjust volume, and BASS and TREBLE to adjust the tone.
TO PLAY EQUIPMENT CONNECTED TO THE AUX 1 OR AUX 2 JACKS
1.Set INPUT SELECTOR to AUX1 or AUX2.
2.Set up the connected equipment for play.
3.Use VOLUME to adjust volume, and BASS and TREBLE to adjust the tone.
8