Multiquip DCA-25SSIU2 50 HZ- Gauge Reading, How to Read the OutputTerminal Gauges

DCA-25SSIU2 (50 HZ)— GAUGE READING

How to Read the OutputTerminal Gauges.

The gauges and selector switches on the control panel DO NOT effect the generator output. They are provided to help observe how much power is being supplied at the Output terminals lugs.

Before taking a reading off either gauge, set the Voltage Selector Switch (Figure 17) to the position which produces the required voltage (For example, for 3Ø 200V,

choose the center 3Ø 240/ 139V position on the volt- age selector switch.)

Reading Amperage

To determine the amperage at a terminal lug, set the AC Ammeter Change-Over Switch to the appropriate setting (Figure 20) to activate the AC Ammeter Gauge (Figure 21) and read the available amperage at the terminal lug.

For example, to measure the amperage at the U terminal lug, set the AC Ammeter Change-Over Switch to U and read the AC Ammeter Gauge.

Figure 17. Voltage

Selector Switch 240/

139VThree Phase

Position

NOTE

Reading Voltage

For 3Ø 200V/1Ø,115V, place the Voltage Selector Switch in the 3 Phase 240/139 position.

Figure 20. AC Ammeter

Change-Over Switch

NOTE

Figure 21. AC Ammeter (Amp reading on U lug)

The ammeter gauge will only show a reading when the Output Terminal Lugs are connected to a load and in use.

To determine the voltage between two terminal lugs, set the AC Voltmeter Change-Over Switch to the appropriate setting (Figure 18) to activate the AC Voltmeter Gauge (Figure 19) and read the available voltage between the two lugs.

For example, to measure the voltage between the W and U terminal lugs, set the AC Voltmeter Change-Over Switch to W-U and read the AC Voltmeter Gauge.

Figure 18. AC Voltmeter Figure 19. AC Voltmeter Gauge Change-Over Switch

DCA-25SSIU2 (50 HZ)— OPERATION AND PARTS MANUAL — REV. #0 (03/11/05) — PAGE 27