General Safety Rules
1.Never edge while people, especially children or pets are nearby.
2.Before using, always visually inspect to see that the blade, blade bolts and cutter assembly are not worn or damaged.
3.Do not start the motor when a bystander is standing in front of the blade.
4.Do not put hands or feet near or under rotating parts.
5.Never lean over the rotating cutting head. Rocks or other debris could be thrown into eyes and face and cause serious personal injury.
6.Use extreme caution when reversing or pulling the edger toward you
7.Make sure the blade has stopped before crossing surfaces other than grass and when transporting the edger to and from the area to be edged.
8.Never operate the edger with defective, missing or incorrectly fitted guards.
WARNING
WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS, INCLUDING THE FOLLOWING, SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND PERSONAL INJURY.
Pay particular attention to all sections regarding safety.
Read and understand all these instructions before operating this product and save these instructions. Be familiar with the controls and the proper use of equipment.
For safe operations:
1.Keep work area clean.
Cluttered areas and benches invite injuries.
2.Consider work area environment.
Do not expose power tools to rain. Do not use power tools in damp or wet locations. Keep work area well lit. Do not use power tools where there is risk of fire or explosion.
3.Guard against electric shock.
Avoid body contact with earthed or grounded surfaces, e.g. pipes, radiators, stoves, ovens, refrigerators.
4.Keep children away.
Do not let visitors touch the tool or extension cord. All visitors should be kept away from area. Local regulations may restrict the age of the operator.
5.Store idle tools.
When not in use, tools should be stored in a dry, high or locked up place, out of reach of children.
6.Do not force the tool.
It will do the job better and safer at the rate for which it was intended. Walk, never run.
7.Use the right tool.
Do not force small tools or attachments to do the job of a heavy duty tool. Do not use tools for purposes not intended; for example, do not use chain saw attachment to cut tree limbs or logs.
8.Dress properly.
Do not wear loose clothing or jewelry that can be caught in moving parts. Long trousers,
9.Use protective equipment.
To avoid injury, wear ear, eye protection, face or dust mask if the operation is dusty. To avoid injury from falling branches, wear helmet. Eye protection must meet ANSI Z 87.1 requirements.
10.Do not abuse the cord.
Never carry the tool by the cord or yank it to disconnect it from the socket. Keep the cord away from heat, oil and sharp edges.
11.Maintain tool with care.
Keep cutting tools sharp and clean for better and safer performance. Follow instructions for lubrication and changing accessories. Inspect tool cord periodically and if damaged, have it repaired by an authorized service facility. Inspect extension cords periodically and replace, if damaged. Keep handles dry, clean and free from oil and grease.
12.Disconnect tools.
When not in use, before servicing and when changing accessories such as blades, bits and cutters.
13.Remove adjusting keys and wrenches.
Form the habit of checking to see that keys and adjusting wrenches are removed from the tool before turning it on.
14.Avoid unintentional starting.
Do not carry a plugged in tool with a finger on the switch trigger. Ensure switch is off when plugging in.
15.Use outdoor extension leads.
When tool is used outdoors, use only extension cords intended for outdoor use.
16.Important extension cord information:
a. Make sure the extension cords are in good condition before use.
3