Assembling the Edge Trimmer
Tools: 9/16" wrench, pin supplied with the unit or screwdriver
1 2
5
3 | 2 | 1 | 4 |
1. Remove the following parts from the Edge Trimmer |
Assembly: blade mounting bolt #1 by rotating it |
4
3
5
| clockwise, clamping plate #2, gear case cover #3, |
| holding screws #4, and cover #5. (Pictures 1 and 2) |
2. | Install the blade guard to the gear case aligning 3 |
| mounting holes (Picture 4), then put on cover #5, |
| align all holes and install 3 screws. (Picture 5) |
3. | Attach the blade guard to the tube using Clamping |
| bracket and two screws. (Picture 6) |
4. | Install gear case cover (Picture 7), blade (Picture 8), |
| clamping plate (Picture 9), and install blade |
| mounting bolt with washers. Left thread, rotate |
| |
5. | Lock the gear shaft by putting a pin provided or |
| screwdriver through the aligned keyholes in the gear |
| case cover and the gear case. Use a socket wrench to |
| tighten the |
| clockwise to tighten. (Picture 11) |
6. | Split the bracket, install the wheel assembly to the |
| tube, and clamp it at the position best for your job, |
| using two screws. (Picture 12 and 13) |
7. | You can replace loop handle with the |
| handle that comes with your Edge Trimmer |
| Attachment. |
Pin
Picture 11
Picture 1
Gear Case
Picture 3
Cover
Screws
Picture 5
Gear
Case
Cover
Picture 7
Clamping Plate
Picture 9
Bracket
Picture 12
Picture 2
Blade Guard
Picture 4
Shaft
Clamp
Picture 6
Blade
Picture 8
Mounting
Bolt
Picture 10
Picture 13
6