Attaching the Edger to the
Power Head assembly.
No tools are required to attach the Edge Trimmer to the power head assembly.
1. | Pull the spring pin up on the adapter of the power head |
|
| shaft assembly. (Picture 14) |
|
2. | Carefully fit edger drive shaft into adapter, making sure |
|
| that male spline of the inner drive shaft engages into the |
|
| female spline socket of the power head shaft. |
|
| Picture 14 | |
|
|
3.When the drive shaft is properly aligned, the spring pin will drop into the hole on the shaft of the edger attachment. A click should be heard when completed.
4.Insure two shaft parts are fully engaged by twisting them.
5.Full engagement will prevent shaft rotation.
6.Secure assembly by tightening the knob. (Picture 15)
Balancing and Depth Adjustment
Check the balance of the assembled unit. The handles and shoulder harness have been assembled at the factory and set according to the average sized person. This can be adjusted to the operator’s preference.
1. Unit handles can be | Picture 16 |
| |
preference by simply loosening the screws and sliding |
|
| |
handles up or down the shaft. |
|
(Picture 16). The distance between the replacement portion |
|
of the blade and the foremost portion of the guiding handle |
|
should be at least 18" (450mm). (Picture 17) |
|
2. Wheel height can be |
|
and changing the height of the wheel to achieve desired |
|
cutting depth. (Picture 18) |
|
|
|
Picture 17
Picture 15
up
down
Picture 18
7