Land Pride BH3512 Tractor Lower Link, Bucket Installation, Locking Bar Installation Optional

Page 18

Table of Contents

Section 1: Assembly and Set-Up

Bucket Installation

Refer to Figure 1-10:

Assemble the bucket (#1) with the pins (#2) and roll pins (#3) as shown.

Land Pride

	Tractor Lower Link
Bucket Installation
Figure 1-10	Locking Bar Installation
19369	Figure 1-9
19369

Locking Bar Installation (Optional)

1.After the backhoe is attached to the tractor in working position proceed with the following steps to install the lower drawbar link locks in Figure 1-9.

2.Install pins (#3) through eyebolt (#2) with the eyebolts being located on each side of backhoe lower link sockets. Secure pins in place with lynch pins(#4).

3.Install lower link lock angles right (J) and left (K) as indicated in the drawing. Place lockwashers (L) and install nuts (M) on eyebolts and snug nuts in place.

4.Adjust the 3/4” bolt against the tractor drawbar link. Lock adjustment screw (N) with locknut (O).

5.Tighten eyebolt (#2) with nut and jam nut.

Seat Assembly

Refer to Figure 1-11:

Assemble the seat as shown with the 3/8” flange nuts. Adjust seat positioning to your comfort by releasing latch located beneath the front of the seat.

Seat Assembly
Figure 1-11	19368

16 BH3512 Backhoes 340-131M

7/14/08

Image 18

Contents Backhoes Table of Contents For Your Protection Important Safety InformationBe Aware Signal Words Shutdown and StorageTransport Machinery Safely Use Safety Lights and DevicesPractice Safe Maintenance Transporting the Loader and AttachmentKeep Riders Off Machinery Prepare for EmergenciesWear Protective Equipment Avoid High Pressure Fluids Hazard838-380C 838-378C818-339C 839-933C 839-932C Owner Assistance Using This ManualApplication IntroductionBackhoe Operation, Maintenance & Safety Tips Hydraulic System Requirements Assembly and Set-UpTractor Requirements Open Center SystemTable of Contents Choose the Appropriate HosingHydraulic valve can be damaged by Testing Procedure for Hydraulic Circuits Testing Open Center SystemChecking a Single Circuit Checking the Cylinders Testing Closed Center SystemHydraulic Testing Chart Return HoseDipper Stick Cylinder Using Tractor Hydraulics All TractorsUsing Tractor Hydraulics John Deere Mounting The BackhoeTransport Lock Bolts Top Link Tractor Lower Links Seat Assembly Bucket InstallationLocking Bar Installation Optional Tractor Lower LinkTransporting The Backhoe Preparing For OperationOperating The Backhoe Operating InstructionsBoom Control FunctionsStabilizers Dipper Stick And BucketDigging Suggestions Digging at the Correct AngleDipper Stick & Boom Bucket Maintenance and Lubrication MaintenanceBucket Tooth Replacement StorageBucket Pivot LubricationLubrication Bucket Cylinder Base EndBoom Cylinder Rod End Boom PivotBoom Cylinder Base End Stabilizer Arms Boom Swing Cylinder Rod EndBoom Swing Cylinder Base End Speciﬁcations & Capacities BH35 Series BackhoesBH3512 Features and Beneﬁts Features BenefitsTroubleshooting Hydraulic System Problem Cause SolutionLoad drops when valve PerformanceIn-tpi Torque Values ChartAppendix · m Ft-lb Mm x pitch30 BH3512 Backhoes 340-131M Warranty Corporate Ofﬁce PO. Box 5060 Salina, Kansas 67402-5060 USA