Kunz MR44K Assembly Instructions, You should have, A. Assembly Of Rear Wheels And Carrier Arms

Page 5
ASSEMBLY INSTRUCTIONS

ASSEMBLY INSTRUCTIONS

Read the complete assembly instructions before starting the assembly.

You should have:

-one mower deck assembly

-two carrier arm assemblies

-two rear tire assemblies

-one front cross brace tube and one rear cross brace tube with height adjust assy.

-one ATV tongue assembly

A.ASSEMBLY OF REAR WHEELS AND CARRIER ARMS

1. Set the mower deck assembly on wood blocks so that it is suspended off the ground.

Note: The operator controls are on the front of the deck. (Left and right are determined by looking in the direction of travel or by standing at the rear of the deck assembly looking forward.)

2.Install the rear tire assemblies on the carrier arm assemblies. Remove the hex nut and lock washer from the rear tire assembly and install the 5/8”x7-1/2” tire axle bolt through the hole in the carrier arm assembly. See figure 1. Secure assembly with the lock washer and hex nut provided on the rear tire assembly. The rear tires should be offset to the outside of the deck assembly on both sides. See figure 2.

Carrier Arm

 

Rear Tire

 

Assembly

 

 

 

 

 

Bolt

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Hex Nut and

 

 

Lock Washer

Cup Washer

Flat Washer

 

Figure 1: Rear Tire Assembly Installation

4

Image 5
Contents For Models MR44B & MR44K With Assembly InstructionsKUNZ ENGINEERING, INC. / MENDOTA, IL 61342 / PH 1/09SAFETY INTRODUCTION IMPORTANT SAFETY INFORMATION Clean or Replace Any Safety Signs That Are not Readable or Damaged SAFETY SIGNS AND LOCATIONS275003 - Danger 275007 - WarningA. ASSEMBLY OF REAR WHEELS AND CARRIER ARMS ASSEMBLY INSTRUCTIONSYou should have Read the complete assembly instructions before starting the assemblyB. INSTALLATION OF CROSS BRACE TUBES AND HEIGHT ADJUST ASSY Figure 3 Cross Brace Tube Installation Direct Behind Position C. INSTALLATION OF TONGUE ASSEMBLYOffset Position A. TONGUE CONFIGURATIONS AND ADJUSTMENTS OPERATIONS AND ADJUSTMENTSB. ADJUSTING CUTTING HEIGHT Adjust the mower as follows E. MOWER OPERATION C. STARTING ENGINED. SHUTTING OFF ROUGH CUT MOWER WARNING Do not fill fuel tank while engine is running or hot F. DRIVE BELT REMOVAL AND TENSION - Refer to Figure Brake Stud Clearance Disengaged Spring LengthI. STORAGE G. MOWER BLADE REMOVAL, BALANCING & INSTALLATIONH. LUBRICATION DIMENSIONS ACREASE ROUGH CUT MOWER SPECIFICATIONSModel ENGINEDescription ACREASE ROUGH CUT MOWER PARTS LISTDescription 2933 UACREASE 44” ROUGH CUT MOWER PARTSShown on the 57” Rough Cut Mower OPTIONAL EQUIPMENTOPTIONAL WETLANDS KIT OPTIONAL ELECTRIC LIFT KIT OPTIONAL FLOATATION KIT OPTIONALUEQUIPMENT