Connections, Speaker Placement | Marantz SR5400U guide

CONNECTIONS

SPEAKER PLACEMENT

The ideal surround speaker system for this unit is 7-speaker systems, using front left and right speakers, a center speaker, surround left and right speakers, a surround back and a subwoofer.

Surround left and right speakers

Place the speakers right beside of the listening position or a little backward.

Surround back speaker

Place the speaker behind the listening position.

Subwoofer

We recommend using a sub-woofer to have maximum bass effect. Sub-woofer bears only low frequency range so you can place it any where in the room.

CONNECTING SPEAKERS

PASSIVE	POWER	POWERED	FRONT	SURROUND
PASSIVE	POWER	SUBWOOFER	FRONT	SURROUND
SUBWOOFER	AMPLIFIER		RIGHT LEFT	RIGHT LEFT
			or

ENGLISH

For best results we recommend that all front speakers be of the same type, with identical or similar driver units. This will deliver smooth pans across the front sound stage as the action moves from side to side.

Your center channel speaker is very important as over 80 % of the dialog from a typical motion picture emanates from the center channel.

It should possess similar sonic characteristics to the main speakers. Surround channel speakers need not be identical to the front channel speakers, but they should be of high quality.

The surround center speaker is useful for playback

HEIGHT OF THE SPEAKER UNITS

Front left and right speakers, and a center speaker

Align the tweeters and mid-range drivers on the three front speakers at the same height, as best as possible.

Surround left and right speakers, and surround back speaker

Place the surround left, right and surround back speakers higher than your ears by about 70cm – 1m. Also place the speakers at the same height, as

ANTENNA

COMPONENT VIDEO

DVD

DSS/VCR2

MONI.OUT

CB/PB

CR/PR

CB/PB

CR/PR

CB/PB CR/PR

FM (75Ω) GND

VIDEO

DVD

VCR1

DSS/VCR2

MONI.

VCR1

DSS/VCR2

S-VIDEO

DVD

OUT

MONI.OUT

OUT

DIGITAL IN

DIGITAL OUT

RC-5

PREPRE

OPT.

COAX.

OUTOUT

OUT

SWSW

DVD

VCR1

DSS/VCR2

TAPE

CDR/MD

6.1CH

			AC IN
			SERIAL NO.
			SWITCHED UNSWITCHED
			1A 120W MAX 1A 120W MAX
			AC OUTLET
			120V 60HZ
RR	LL	RR	LL

of Dolby Digital Surround EX or DTS-ES. One of the benefits of both Dolby Digital and DTS is that surround channels are discrete full range, while they were frequency limited in earlier “Pro Logic’ type systems.

best as possible.

FRONTFRONT	CENTERCENTER	SURROUNDSURROUND	SURROUNDSURROUND
			BACKBACK

IN	OUT	IN	OUT	IN	OUT	IN	OUT	R	SR	SB	SW
				AUDIO							SPEAKER SYSTEMS
				AUDIO							6 - 8 OHMS

Bass effects are an important part of home theater. For optimal enjoyment a subwoofer should be used as it is optimized for low frequency reproduction. If you have full range front speakers, however, they may be used in place of a subwoofer with proper setting of the switches in the menu system.

70cm

CENTER SURROUND

BACK

	Subwoofer
	Surround Left
	Front Left
Surround Back	Front Center
	Front Right
	Surround Right

Front left and right speakers

We recommend to set the front L and R speakers with 45-60 degrees from the listening position.

Center speaker

Align the front line of the center speaker with the front L/R speakers. Or place the center speaker a little backward from the line.

Note;

•Use magnetically-shielded speakers for front left, right and the center speakers when the speakers are installed near the TV and the TV is a monitor type.

CONNECTING SPEAKER WIRE

1. Strip away approx. 10 mm of wire insulation.

2. Twist the bared wire ends tight, to prevent short circuits.

3. Loosen the knob by turning it counterclockwise.

4. Insert the bare part of the wire into the hole in side of each terminal.

5. Tighten the knob by turning it clockwise to secure the wire.

1.2.

10mm

3.4. 5.