Jonsered CS 2156 manual What is WHAT?, What is what on the chain saw?

Page 24

WHAT IS WHAT?

What is what on the chain saw?

1Cylinder cover

2Front handle

3Front hand guard

4Starter

5Chain oil tank

6Starter handle

7Adjuster screws, carburettor

8Choke control/Start throttle lock

9Rear handle

10Stop switch (Ignition on/off switch.)

11Fuel tank

12Mufﬂer

13Bar tip sprocket

14Chain

15Bar

16Spike bumper

17Chain catcher (Catches chain if it jumps or breaks.)

18Clutch cover

19Right hand guard (Protects right hand if chain breaks or jumps.)

20Throttle control

21Throttle lock (Prevents accidental operation of throttle control.)

22Decompression valve (CS 2159)

23Combination spanner

24Chain tensioning screw

25Operator’s manual (EPA)

26Bar guard

27Oil pump adjustment screw

28Switch for heated handle (W)

24 – English

Image 24

Contents EPA KEY to Symbols Key to symbolsContents EPA Safety Instructions Machine′s safety equipmentPersonal protective equipment Chain brake and front hand guard Stop switch Throttle lockChain catcher Right hand guardMufﬂer Checking brake band wearChecking the front hand guard Checking the inertia brake release Checking the brake triggerThrottle lock Chain catcherStop switch Cutting equipmentGeneral rules Vibration damping systemCutting equipment designed to minimise kickback BarChain Some terms that describe the bar and chainSharpening your chain and adjusting raker clearance General information on sharpening cutting teethSharpening cutting teeth With a badly sharpened chainGeneral advice on setting raker clearance Setting the raker clearanceTensioning the chain If the raker clearance is too largeLubricating cutting equipment Chain oilFilling with chain oil Checking chain lubricationNeedle bearing lubrication Checking wear on cutting equipmentChain drive sprocket How to avoid kickback What is kickback?Do not let go of the handles General safety precautions StartingFuel safety Basic safety rulesGeneral working instructions Transport and storageBasic cutting technique GeneralTerms Cutting LimbingTree felling technique Safe distanceFelling direction Clearing the trunk and preparing your retreatFelling cut General advice Freeing a tree that has fallen badlyCutting the trunk into logs Freeing a trapped treeWhat is WHAT? What is what on the chain saw?Assembly Fitting the bar and chainFuel Handling FuelFollowing applies to chain saws with catalytic converters Chain oil FuellingStarting and Stopping Starting and stoppingCold engine Warm engineStopping Maintenance CarburettorCorrectly adjusted carburettor StarterChanging a broken or worn starter cord Tensioning the recoil springAir ﬁlter Spark plugMufﬂer Fitting the starterAdjustment of the oil pump Centrifugal cleaning TurboWhen making adjustments Needle bearing lubricationTemperature 0 C 32 F or colder Temperature -5C 23 F or colderHeated handles CS 2156W, CS 2159W Electrical carburettor heating CS 2156WH, CS 2159WHDaily maintenance Weekly maintenance Monthly maintenanceBelow you will ﬁnd some general maintenance instructions Technical Data Technical dataBar Length Pitch, inch Max nose Chain Inches Radius 050/1,3 mm 20BP063/1,6 mm 22BP Federal Emission Control Warranty Statement Your Warranty Rights and Obligations1088891-95