TOWERS AND DOORS INSTALLATION
STEP 4
Take the side support rails and install a cover cap and wall bracket on each end. Place the center support rail into slot on each tower. If rail does not readily fit into slots, it may be necessary to loosen the bolts holding towers to base (it may only be necessary to loosen one tower). DO NOT FORCE CENTER RAIL INTO SLOTS. With center support rail in position, install hold down brackets but do not tighten screws. Place the side support rails into the slot on each water tower. With side rails in position install hold down brackets, but do not tighten screws. Check side support rails for level and mark on the finished wall where to attach rail bracket. See DETAIL A. Drill 3/16" holes and secure bracket with screws and wall anchors provided. Slide cover cap over rail bracket. If a tower bolt was loosened, retighten while checking the plumb of the tower. Tighten screws on all hold down brackets.
COVER CAP (2)
SIDE SUPPORT RAIL (2)
HOLD DOWN BRACKETS (5)
RAIL BRACKET (2)
CENTER SUPPORT RAIL
WATER TOWER DOOR POST | WATER TOWER JAMB |
ATTACH RAIL
BRACKET TO WALL
SECURE RAIL TO
BRACKET (TURN CW
TO TIGHTEN)
SCREW (8 PER WATER TOWER) (4 PER AIR TOWER)
RAIL HOLD DOWN BRACKET (1 PER AIR TOWER)
(2 PER WATER TOWER)
MOVE COVER CAP
OVER BRACKET
DETAIL A
9
Jacuzzi Whirlpool Bath© BY82000 03/05