3.Attach the seat base mechanism to the underside of the seat cushion using the included Allen wrench and 4 of the screws. Make sure the arrow on the seat base mechanism is pointing toward the front edge of the seat cushion (label on seat cushion).
5.Attach the armrests (labeled as R and L for right and left sides) onto the seat cushion using the included Allen wrench and 4 of the screws (2 on each side). DO NOT TIGHTEN THE SCREWS COMPLETELY.
Figure 4
4.Place the seat cushion on top of the pneumatic cylinder. Make sure the cylinder is positioned properly by sitting on the seat cushion.
Figure 6
6.Connect remote arm wires to chair wires and feed into the opening in the side of the chair.
Figure 7A | Figure 7B |
Figure 5
6 | 7 |