This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user authority to operate
the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection agains harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Product Care & Maintenance
To Clean
•Disconnect the office chair from power source before cleaning.
•A soft, damp cloth may be used for the chair. When cleaning the controller use a dry cloth only.
•Dust may be removed from the backrest or armrest with a vacuum.
•Do not use abrasive cleaners, brushes, gasoline, kerosene, polish or paint thinner to clean.
•The cushions are not machine washable. Do not immerse in liquids to clean.
To Store
•Avoid contact with sharp edges or pointed objects, which might damage/puncture the fabric.
•Do not store near heat or open flame. Do not leave this product exposed to direct sunlight for long periods of time. This may cause fading.
Other General Care & Use Guidelines
•Foreign objects should not be inserted between the massage nodes or the unit housing.
•The mechanics of the product are specially designed and constructed to be maintenance free.
No periodic lubrication or servicing is required.
•To retract cord into chair for storage or transport, unplug the chair from the wall. Loosely hold the cord and press the cord retraction button just above the cord on the chair. Gently guide the cord back into the chair while holding the retraction button.
Tilt Lock:
To engage the tilt lock, make sure the chair is fully upright. Grasp the black handle located beneath the seat on the right side of the chair and push straight in (toward the chair). The tilt lock mechanism will click into place. The chair is now unable to recline. To disengage the tilt lock, make sure the chair is fully upright an pull the handle straight out (away from the chair). The chair is now able to recline.
Height Adjust:
To raise the height of the chair, grasp the black handle located beneath the seat on the right side of the chair and lift up. Do not sit in the chair or put pressure on the seat while you are raising the handle. Release the handle when the chair is at the desired height. To lower the seat height, sit in the chair and grasp the black handle located beneath the seat on the right side of the chair and pull straight up. The chair will lower due to the weight on the chair. Release the handle when the chair reaches the desired height.
Comfort Flap
Shiatsu Massage with Heat
Integrated
Controls
Comfortable 
Padded Armrests
Adjustable
Seat Height
Integrated Cord Management
12 | 13 |